either paper near end sense or paper feed action. It is also noticed that some market available paper roll has extremely light bobbin, easily causing the paper roll to go off position when paper feeding with low remaining paper. In this case, the paper near end sensor may function abnormally and it would be a good solution to set in the setup window to have the printer to send busy only when input buffer is full and not based on every off line signal.
3.Paper cutting
The paper advance after a protective cut is now set to 12
mm.In case the user uses direct cut instead of protective cut to have something like a logo printed on top of each slip, it is also highly suggested to print the logo and necessary paper feeding to make 12 mm paper advance right after each cut to prevent curling up and jamming of paper front edge inside the paper exit slot.
4.Wall mount application
In wall mount application, the option kit will include screws plastic cotters and a paper roll shaft. Screws and cotters are to be inserted to holes drilled on wall and the paper roll shaft should go through the paper roll and seat in hold on paper roll compartment wall. The paper near end sensor must be readjusted for wall mount application as it approaches the paper roll from different direction for desktop application.
2 - 6