Powering up the system
TV/CATV TV/AV MUTE POWER
1.Press and hole the POWER On/Off button on the remote until the green LED on the front of the monitor is illuminated. The On Screen Display will show the position of the system at the time it was last turned off (for example, if you were watching CATV Channel 38 when you last turned the power off, the system will display "CATV CH 38").
2.Turn off the system by pressing the POWER On/Off button on the remote. The screen will go dark and the green LED will go out; the tuner unit will be in STANDBY mode.
Selecting the input Mode
12
56
9 0
VOL CH
TV/CATV TV/AV
34
7 8
FM/AM SETUP
Monitor
UP
+ FUNC
DN
- MODE
MUTE POWER
Your Video Tuner can switch between four different
video sources using the remote control. These modes are as
follows; TV Mode: for receiving TV Channels
CATV Mode: for receiving satellite dish, Cable or other broadcast source video
AV1:External audio and video inputs for DVD,VCR or video game AV2:External audio and video inputs for DVD,VCR or video game
Programming Channels for TV/CATV
The tuner system can memorize channels in both TV (VHF and UHF) mode and CATV mode in two independent memory sections. To memorize channelss in either mode, press the AUTO PROG button on the
12
56
9 0
VOL CH
TV/CATV TV/AV
34
7 8
FM/AM SETUP
Monitor
UP
+ FUNC
DN
- MODE
MUTE POWER
begin scanning all of the available channels and put them int memory. During this programming cycle, the screen will display "AUTO"in the upper left corner.
IF you wish to interrupt the auto programming mode. press the Channel button. Interrupting in this manner is not recommended, however, because it will not program all channels properly.
12
56
9 0
VOL CH
34
7 8
FM/AM SETUP
Monitor
UP
+ FUNC
DN
- MODE
Selecting Channels
Use the Channel
and 
buttons for selecting channels. If the unit has been auto programmed, the
and 
buttons will step
TV/CATV TV/AV MUTE POWER
up or down through only the memorized channels. Pressing and holding the 
or 
buttons in the CATV mode will cause the unit to step automatically through all available channels until the Button is released; pressing and holding these buttons in TV mode will cause the tuner to "seek" any air channel which can be received.
12
56
9 0
VOL CH
34
7 8
FM/AM SETUP
Monitor
UP
+ FUNC
DN
- MODE
14