3M S50C, X50C manual Setting UP the Projector, Adjusting the Projectors Elevator Foot

SETTING UP THE PROJECTOR

CAUTION • Install the projector in a suitable environment according to instructions of the "Product Safety Guide" and this "Operator's Guide".

•If you press the elevator button without holding the projector, the projector might crash down, overturn, smash your fingers and possibly result in malfunction. To prevent damaging the projector and injuring yourself, ALWAYS HOLD THE PROJECTOR whenever using the elevator button to adjust the elevator foot.

Adjusting the Projector's Elevator Foot

You can use the elevator foot to make adjustments if the surface on which you need to set the projector is uneven or if you otherwise need to adjust the angle of projection. The adjustment range of the elevator foot is 0 to 9 degrees.

1 Pressbutton and hold in the elevator

Raise or lower the projector to the

2 desired height and then release the elevator button

When you release the elevator button, the elevator foot will lock into position.

3	As necessary, you can also finely
	adjust the left-right slope of the

projector by twisting the rear foot
adjuster screw by hand	9

Rear Foot Adjuster

6