3M MP8640 manual Safeguards, Intended USE

Page 3

Safeguards

INTENDED USE

Before operating the machine, please read the entire manual thoroughly. The 3MMultimedia Projector 8640 was designed, built and tested for use indoors, using 3Mbrand lamps and nominal local voltages. The use of other replacement lamps, outdoor operation or different voltages has not been tested and could damage the projector or peripheral equipment and/or create a potentially unsafe operating condition.

IMPORTANT SAFEGUARDS

1.Read and understand all instructions before using.

Pay particular attention to areas where this symbol is shown.

WARNING - Indicates a potentially hazardous situation which, if not avoided, could result in death or serious injury.

Caution - Indicates a potentially hazardous situation which, if not avoided, could result in minor or moderate injury. It may also be used to alert against unsafe practices.

2.Close supervision is necessary when any appliance is used by or near children. Do not leave appliance unattended while in use.

3.Never look directly into the projector lens when the lamp is on. The metal halide lamp produces a strong light which could damage your eyesight.

4.Care must be taken as burns can occur from touching hot parts.

5.Do not operate appliance with a damaged cord or if the appliance has been dropped or damaged – until it has been examined by a qualified service technician.

6.Position the cord so that it will not be tripped over, pulled, or contact hot surfaces.

7.If any extension cord is necessary, a cord with a current rating at least equal to that of the appliance should be used. Cords rated for less amperage than the appliance may overheat.

8.Always unplug appliance from electrical outlet before cleaning and servicing and when not in use. Grasp plug and pull to disconnect.

9.To reduce the risk of electric shock, do not immerse this appliance in water or other liquids.

10.To reduce the risk of electric shock, do not disassemble this appliance, but take it to a qualified technician when service or repair work is required. Incorrect assembly can cause electric shock when the appliance is subsequently used.

11.Connect this appliance to a grounded outlet.

12.Do not expose this projector to direct sunlight, or use it outside.

13.Keep all ventilation openings free of any obstructions.

14.Always open the lens shutter when the projection lamp is on.

SAVE THESE INSTRUCTIONS

The information contained in this manual will help you operate and maintain your 3M MP8640 Multimedia Projector.

© 3M 1997

3MMultimedia Projector MP8640

3

Image 3
Contents MP8640 Multimedia Projector Table of Contents Intended USE SafeguardsThank YOU for Choosing 3M WarrantyKeep Your Packaging Materials Contents of Shipping BoxOptional Accessories UnpackProduct Description Machine CharacteristicsInput button Main Unit IdentificationSystem Set Up connecting various equipment Stick Switch Remote Control Transmitter IdentificationBasic Operations InstallationTurn the Main Power switch of the projector on Hold the STANDBY/ON button for 3-5 seconds Turn Off the Power√ To reset a single item from Setup menu Adjustment and FunctionsTo return to the factory default setting √ Highlight Setup option √ To reset the entire Setup menuSide view How To Use Foot AdjustersColor BAL BrightnessColor SizeVIDEO2 RGB1RGB2 VIDEO1Image BlankReveal Language OPTConnection to Signal Terminals Connection to the Video Signal TerminalConnection to the RGB Signal Terminal Example of computer signal Mouse emulation Connection to the Control Signal TerminalRS 232 Control Cable not included with basic packout Maintenance Cleaning the Air FilterMessage Table Lamp Display Lamp Operation HoursReplacing the Lamp Symptom Cause Solution When You Think Something Is WrongTechnical Specifications SpecificationsAccessories Dimension Diagram 3M Austin Center 3M Canada 3M Mexico, S.A. de C.V 3M Europe