3M MP8790 manual Turning on the Power, Selecting an Input Signal

TURNING ON THE POWER (continued)

Selecting an Input Signal

5

Using the remote control

If selecting RGB input

Press the RGB button

Press this button to toggle between the devices connected to RGB IN 1 and 2. As illustrated below, each time you press the RGB button, the projector switches between RGB IN 1 and 2. Select the signal you wish to project.

• When BNC (RGB) is selected: RGB

RGB BNC(RGB) DVI

•When BNC (COMPONENT) is selected:

RGB DVI

If selecting video input Press the VIDEO button

Press this button to toggle between the	VIDEO
devices connected to VIDEO IN, S-VIDEO
IN and COMPONENT VIDEO. As
illustrated below, each time you press the

VIDEO button, the projector switches between VIDEO IN, S-VIDEO IN and COMPONENT VIDEO. Select the signal you wish to project.

•When BNC (RGB) is selected:

VIDEO IN S-VIDEO IN COMPONENT VIDEO

•When BNC (COMPONENT) is selected:

VIDEO IN S-VIDEO IN COMPONENT VIDEO

BNC(COMPONENT)

Using the projector's control panel

Turn the INPUT dial

Turning the dial cycles through the inputs as shown below. Select the terminal to which the signal you want to project is input.

•When BNC (RGB) is selected:

RGB BNC(RGB) DVI

COMPONENT VIDEO S-VIDEO VIDEO

•When BNC (COMPONENT) is selected:

RGB BNC(COMPONENT) DVI

COMPONENT VIDEO S-VIDEO VIDEO

NOTE

Turn the INPUT dial and set it at the click point, otherwise input signal selection may be incorrect.

6	Use the ZOOM	/	buttons to adjust	ZOOM
	the screen size				ZOOM
				(Control panel)	(Remote control)
7	Use the FOCUS	/	buttons to adjust	FOCUS
	the focus				FOCUS
				(Control panel)	(Remote control)

16