A.7 Connection to the Control Signal Terminal
a)Mouse emulation
(1)While the projector and computer are turned OFF, connect the projector and the mouse terminal of computer using an appropriate cable (PS/2, Serial or ADB).
(2)Turn ON the projector.
(3)Turn ON the computer.
(4)Select the correct mouse driver for the application. See computer's User Manual for this procedure.
✔Note
In some Notebook computers with an internal pointing device, mouse emulation will not work unless the internal pointing device is disabled. In this case, disable the internal pointing device in BIOS setting. Check the computer's manual for procedure to follow to disable internal pointing device in BIOS setting.
Caution
Turn off the power to both the projector and computer before connecting. Connect the computer to the control terminal of the projector using the appropriate cable.
PS/2 mouse
1 | 5 |
6 | 10 |
11 | 15 |
ADB mouse
1 | 5 |
6 | 10 |
11 | 15 |
Projector |
|
| 1 |
CLK | 2 |
DATA 3 | |
| 4 |
| 5 |
SEL0 | 6 |
RTS | 7 |
| 8 |
+5V | 9 |
GND 10 11 12 13 14 15
Projector
1 SDATA 2 3 4 5 6
RTS 7 8
+5V 9 GND 10 11 12 13 14 15
| Computer | Mini DIN 6pin | ||
1 | DATA |
|
| |
2 |
| 6 | 5 | |
3 | GND | |||
4 | 3 | |||
4 | +5V | |||
|
| |||
5 | CLK | 2 | 1 | |
6 |
|
|
| |
PS/2 port
| Computer | Mini DIN 4pin | ||
1 | ADS |
|
| |
2 | (POWER ON) | 4 | 3 | |
3 | +5V | |||
|
| |||
4 | GND | 2 | 1 | |
ADB port
TECHNICAL
© 3M 1999 | 3M ™ Multimedia Projector MP8745 |