OPERATIONS
Switching the Power Supply ON/OFF
Switching Power ON
1.Check that the power cord is connected correctly.
2.Set the power switch to [ ]. The standby mode is selected, and the Power indicator is turned to orange.
3.Press the STANDBY/ON 
button on the control panel or the remote control transmitter.
4.The Power indicator ceases blinking and turns to green when power is on. Open the slide lens door.
5.Adjust picture size using the projection lens Zoom Knob.
6.Adjust focus using the projection lens Focus Ring.
POWER Indicator | STANDBY/ON Button | STANDBY/ | STANDBY/ON | VIDEO |
| ||||
| ON Button |
| LASER | |
|
| BLANK | RGB | |
|
|
|
ENGLISH
ZOOM knob
FOCUS ring
Power Switch | Slide Lens door |
AUTO
MENU | POSITION |
MENU SELECT | |
| RESET |
| FREEZE |
MAGNIFY | VOLUME |
| OFF |
| MUTE |
Switching Power OFF
1.Press the STANDBY/ON button on the control panel or the remote control transmitter for approximately two second. The projector lamp is extinguished and lamp cooling begins. The
Power indicator blinks orange during lamp cooling. Pressing the STANDBY/ON 
button has no effect while the Power indicator is blinking.
2.The system assumes the Standby mode when cooling is complete, and the Power indicator ceases blinking and changes to orange. Check that the indicator is orange and set the Power switch to [O].
3.The Power indicator is extinguished when power is off. Do not forget to close the lens door.
WARNING
Please read this manual, and the separate “SAFETY INSTRUCTIONS” thoroughly before using the equipment. Always ensure that the equipment is used safely.
NOTE:
•Except in emergencies, do not turn off unless the Power indicator is orange as it will reduce the life of the projector lamp.
•To prevent any troble, turn on/off the projector when the computer or video tape recorder is OFF. Providing a