LG Electronics AF115 owner manual Safety Instructions, Indoor Installation

Page 4

Safety Instructions

Safety Instructions

Please take note of the safety instructions to prevent any potential accident or misuse of the projector.

Safety Instructions are given in two forms as detailed below.

WARNING : The violation of this instruction may cause serious injuries and even death.

NOTES : The violation of this instruction may cause light injuries or damage to the projector.

After reading this manual, keep it in the place that the user can access it easily.

Indoor Installation

Do not place the Projector in direct sunlight or near heat sources such as radiators, fires and stove etc.

This may cause a fire hazard !

WARNING

Do not place inflammable materi-

Do not allow children to hang on

als beside the projector

the installed projector.

This may cause a fire hazard !

They may cause the projector to fall,

causing injury or death.

 

 

Indoor Installation

NOTES

 

 

 

Disconnect the power and remove all connections before moving.

Do not place the projector close to sources of steam or oil such

as a humidifier.

This may create a fire hazard or an electric shock hazard !

Do not place the projector where it might be exposed to dust.

This may cause a fire hazard or damage to the unit!

When installing the projector on a table, be careful not to place it near the edge.

This may cause the projector to fall causing serious injury to a child or adult and serious damage to the projector.

Only use a suitable stand.

Only use the projector on a level and stable surface.

It may fall and cause injury and/or damage to the unit.

Ensure good ventilation around the projector. The distance between the projector and the wall should be more than 30cm/12 inches.

An excessive increase in its internal temperature may cause a fire hazard or damage to the unit!

Do not block the vents of the pro- jector or restrict air-flow in any way.

This would cause the internal tempera- ture to increase and could cause a fire hazard or damage to the unit!

Do not place the projector directly on a carpet, rug or place where ventilation is restricted.

This would cause its internal temperature to increase and might create a fire hazard or damage the unit.

 

Outdoor Installation

WARNING

 

 

 

Do not use the projector in a damp place such as a bathroom where it is likely to get wet.

This may cause a fire or an electric shock hazard !

 

Power

WARNING

 

 

 

Earth ground wire should be con- nected.

If the earth ground wire is not connected, there is a possible danger of electric shock! If grounding methods are not possible, a separate circuit breaker should be installed by a qualified electrician.

Do not connect ground to telephone wires, lightning rods or gas pipe.

The power plug should be inserted fully into the power outlet to avoid a fire hazard !

This may cause a fire hazard or damage the unit.

Do not place heavy objects on the power cord.

This may cause a fire or an electric shock hazard !

4

Image 4
Contents AF115 Lcos Projector Contents Safety Instructions Indoor InstallationUsing Cleaning Names of parts Main BodyConnecting Part Control Panel Remote Control Installing BatteriesProjector Status Indicators Accessories Optional ExtrasInstalling and Composition Installation InstructionsPositioning the Projector Projection distance based on the picture formatUsing Kensington Security System Turning on the Projector Turning off the ProjectorSelecting source mode Focus and Position of the Screen ImageConnecting to a Desktop PC Connecting to a Video SourceHow to connect ConnectionConnecting to a DVD Connecting to a D-TV Set-Top BoxHow to connect a Hdmi source How to connect a Component sourceAdjusting Video Picture modeFunction Auto Iris Function Advanced Control FunctionFresh Colour Adjusts image colors close to natural colors Advanced Picture Reset Function Adjustment You can select Low, Medium or HighTo Change PJT Mode Using Aspect Ratio FunctionAuto configure Function Using Keystone FunctionTest Pattern Function RGB Config. Function Screen Reset FunctionUsing Blank Function Using Still FunctionSelecting Language Selecting Blank image color Sleep time FunctionAuto sleep Function Option Reset FunctionTo See The Projector Information Supported Monitor Display DVD/DTV InputMaintenance Cleaning the lensCleaning the Projector Case Cleaning the FilterLamp Replacement Be careful when replacing lampTo obtain a replacement Lamp unit Replacing the LampReplacing the Lamp Lift the lamp up from the projectorRegarding the projector lamp control Specifications Operating Condition TemperatureHumidity Lamp power consumption AF115 AF115-JS