LG Electronics 47LV35A, 55LV35A owner manual Picture ID, Off

ENGLISH

44 CUSTOMIZING SETTINGS

Picture ID

Picture ID is used to change the settings of a	2 To change the Picture ID, press the ON button,
specific display using a single IR receiver for	or the left and right arrow buttons continuously.
multi-vision. The set receiving the IR signal
	Assign the ID you want.
communicates with another set via an RS232C
connection. Each set is identified by a Set ID. If
you assign the Picture ID using the remote control,		Picture ID
only displays with the same Picture ID and Set ID
can be controlled remotely.			◀ Off ▶
			Close

IR Receiver

Picture ID

◄ Off ►

Close

yyIf you assign the Set ID to each set with multi-vision, and then assign the Picture ID using the red button on the remote control, the key command is displayed for the set with the same Set ID and Picture ID. A set with different Set IDs and Picture IDs cannot be controlled by IR signals.

2X2 Multi-Vision

Set IDs are assigned as shown in the picture.

1Press the red ON button on the remote control to assign the Picture ID.

NOTE

yyFor example, if the Picture ID is assigned to 2, the upper right display (Set ID: 2) can be controlled by IR signals.

yyFor each set, you can change the settings for the PICTURE, TIME, NETWORK and MY MEDIA menus or the hot keys on the remote control.

yyIf you press the green OFF button for Picture IDs, the Picture IDs for all sets are turned off. If you then press any button on the remote control, all sets will start working again.

yyPicture ID will be disabled while using the MY MEDIA menu.

yyIf Picture ID is set to Off, holding buttons on the remote control will execute only one action at a time.