ASSEMBLING AND PREPARING 7
3 Press the (Power) button on the front panel | NOTE |
to turn the power on. |
|
CAUTION
Unplug the power cord before moving the Monitor to another location. Otherwise electric shock may occur.
Front 
Rear
ENGLISH
WARNING
To avoid injury to the fingers when adjusting the screen, do not hold the upper part of the stand as shown below.
yyTilt from 15 to 58 degrees up or down to adjust the angle of the Monitor set to suit your view.
yyAvoid using the product in a high temperature and high humidity area. Moving the monitor from a environment like this to an air conditioned area may cause moisture formation inside the glass. This moisture will be dissipate over time, which may vary depending on the operating environment.
Using the Kensington security system
Do not touch or press the screen when adjusting the angle of the monitor.
WARNING
Attach the rubber like the below picture. If not, the fingers can be pinched or get damaged.
The Kensington security system connector is located at the back of the Monitor set. For more information of installation and using, refer to the manual supplied with the Kensington security system or visit http://www.kensington.com.
Connect the Kensington security system cable between the Monitor set and a table.
NOTE
The Kensington security system is optional. You can obtain it from most electronics stores.