Mitsubishi A1SJ71E71N-B2, E71N-U-HW SW1, OFF on, SW2 SW6 SW3, SW4, SW5, SW7 OFF, SW8

(3)Communications exchange condition setting switch setting Set the conditions for data communication with other nodes.

Communications		Switch	Setting designation		Setting contents
exchange condition
	setting switch
				Selects the line processing when the
			Line processing	TCP ULP time out error occurrence.
		SW1	selection during	( 1)
			TCP timeout error	OFF	Close the circuit.
				ON	Do not close the circuit.
				Selects	the type of data code for
				exchanging data with the remote node.
		SW2	Data code setting	OFF	Conducts exchange in binary
					code.
	OFF ON			ON	Conducts exchange in ASCII
					code.
	SW1
		SW3 to	—	Usage not possible (Fixed to OFF)
	SW2	SW6
	SW3
				Selects whether to approve or forbid
	SW4
				data arriving from the remote node
	SW5		CPU exchange
		SW7		when a PLC CPU is running.
	SW6		timing setting
	SW7			OFF	Writing prohibited.
	SW8			ON	Writing approved.
				Selects	the initial processing starts up
				timing. ( 2)
					Quick start (starts without a
			Initial timing	OFF	delay time)---Set when one
		SW8			network is used for the entire
			setting		configuration.
					Normal start (start after a delay
				ON	of 20 seconds)---Use when the
					entire configurations is made
					up of multiple networks.
			(This is set at "OFF"	at the	time of shipping from factory.)
1	Set to OFF for normal use.
	When a TCP ULP time out error (error code: 9059H) occurs due to data transfer from
	remote node while this switch is set to ON, run the close and open operations with the
	sequence program.
2	Set to OFF for normal use.

7