Mitsubishi Electronics EX100U user manual When using the projector in Europe, Compliance Notice

Page 2

CAUTION

RISK OF ELECTRIC SHOCK

DO NOT OPEN

CAUTION : TO REDUCE THE RISK OF ELECTRIC

SHOCK,

DO NOT REMOVE COVER (OR BACK)

NO USER-SERVICEABLE PARTS INSIDE

REFER SERVICING TO QUALIFIED

SERVICE PERSONNEL.

The lightning flash with arrowhead symbol within an equilateral triangle is intended to alert the user to the presence of uninsulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock.

The exclamation point within an equilateral triangle is intended to alert the user to the pres- ence of important operating and maintenance (servicing) instructions in the literature accom- panying the appliance.

WARNING:

TO PREVENT FIRE OR SHOCK HAZARD, DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE.

CAUTION:

TO PREVENT ELECTRIC SHOCK, DO NOT USE THIS (POLARIZED) PLUG WITH AN EXTENSION CORD, RECEPTA- CLE OR OTHER OUTLET UNLESS THE BLADES CAN BE FULLY INSERTED TO PREVENT BLADE EXPOSURE.

NOTE:

SINCE THIS PROJECTOR IS PLUGGABLE EQUIPMENT, THE SOCKET-OUTLET SHALL BE INSTALLED NEAR THE EQUIPMENT AND SHALL BE EASILY ACCESSIBLE.

WARNING

Use the attached specified power supply cord. If you use another power supply cord, it may cause interfer- ence with radio and television reception.

Use the attached RGB cable or RS-232C cable with this equipment so as to keep interference within the limit of an FCC Class B device.

This apparatus must be grounded.

DO NOT LOOK DIRECTLY INTO THE LENS WHEN THE PROJECTOR IS IN THE POWER ON MODE.

CAUTION

Not for use in a computer room as defined in the Stand- ard for the Protection of Electronic Computer/Data Processing Equipment, ANSI/NFPA 75.

When using the projector in Europe:

COMPLIANCE NOTICE

This Projector complies with the requirements of the EC Directive 89/336/EEC "EMC Directive" as amended by Directive 92/31/EEC and 93/68/EEC, and 73/23/EEC "Low Voltage Directive" as amended by Directive 93/68/ EEC.

The electro-magnetic susceptibility has been chosen at a level that gains proper operation in residential areas, on business and light industrial premises and on small- scale enterprises, inside as well as outside of the buildings. All places of operation are characterised by their connection to the public low voltage power supply system.

WARNING

Use the attached RGB cable or RS-232C cable with this equipment so as to keep interference within the limits of an EN55022 Class B device.

Please follow WARNING instructions.

EN - 2

Image 2 Contents
EX100 ES100 When using the projector in Europe Compliance NoticeContents Important safeguards Place of installation Do not keep using the damaged projectorDo not look into the lens when the projector is oper- ating Never remove the cabinet Do not modify the projectorTerminal board OverviewControl panel Bottom side Remote control Adjustment foot Front Lamp cover Adjustment feet RearOperation range of the remote control Remote controlBattery installation Reception angle verticalRear projection InstallationLayout of the projector Front projectionProjector + DVD player or Hdtv decoder Basic connectionsProjector + AV device About DDC Projector + ComputerFor Macintosh For computer with Mini D-SUBPreparation Adjustment of the projection angleAfter using the projector Preparation for projectionPower-on Basic operationAnamorphic mode Power-offVolume from the speaker Auto Position buttonMenu operation Basic operationMenu operation Signal User No need to adjust in normal use Color temperature Image adjustmentImage adjustment About color temperatureAdjustment of the image from the computer Simple adjustment methodPage-up and page-down Advanced featuresStill ConnectionTo cancel the password function Password functionTo enable the password function Reset of the lamp operation time Lamp replacementInterval of lamp replacement Images arent projected on the screen TroubleshootingProblem Cause and solution Troubleshooting Images arent projected correctlyOthers Cleaning of the projector and the ventilation slotsCleaning of the lens Indicators Normal conditionSpecifications Kensington LockReplacement part SpecificationsCGA84 Mitsubishi Electric Corporation