Mitsubishi Electronics SD110 Adjustment of the image from the computer, Simple adjustment method

Adjustment of the image from the computer

This projector adjusts the format of the video signal supplied from the computer. However, sometimes images are not pro- jected correctly owing to the type of the computer used. When the image from the computer isn’t projected correctly, press the AUTO POSITION button. (See page 14.) If the image isn’t projected correctly yet, adjust the image from the computer using the menu.

Simple adjustment method

1.	Select HORIZ. POSITION in the SIGNAL menu.
2.	Press the W or X button to adjust the horizontal start posi-
	tion (or the left side of the image).
3.	Select TRACKING in the SIGNAL menu.
4.	Press the W or X button to adjust the horizontal end posi-
	tion (or the right edge of the image).
5.	Repeat steps 1 to 4 for optimum adjustment results.

ENGLISH

opt.

SIGNAL

XGA60

6.	Select VERT. POSITION in the SIGNAL menu.
7.	Press the W or X button to adjust the vertical start position

HORIZ. POSITION	0
VERT. POSITION	0
FINE SYNC.	0
TRACKING	0
COMPUTER	RGB
RRGGBB INPUT
SET UP	7.5%
HOLD	ON
USER	OK

To move the image horizontally :

Adjust HORIZ. POSITION in the SIGNAL menu. Press the X button to move the image to the left. Press the W button to move the image to the right.

To move the image vertically :

Adjust VERT. POSITION in the SIGNAL menu. Press the X button to move the image upward. Press the W button to move the image downward.

When the image flickers or the image is out of focus :

Adjust FINE SYNC. in the SIGNAL menu.

When the top part of the image flags :

Change the setting of HOLD in the SIGNAL menu. Select ON , press the ENTER button, and adjust BEGIN or END to

minimize the flagging.

USER

CLAMP

POSITION0

CLAMP WIDTH 1

When wide strips appear :

Adjust CLAMP POSITION or CLAMP WIDTH in the SIGNAL - USER menu.

Important:

Do not change any of the settings in the SIGNAL-USER menu for normal use.

(or the upper edge of the image).

EN-19