Basic connections | Mitsubishi Electronics XD500U-ST instruction

Basic connections (continued)

Projector + Computer

For computer with Mini D-SUB

RGB cable for PC

COMPUTER-IN

MONITOR OUT	AUDIO-IN	AUDIO-OUT
		Audio cable (option)
Necessary when outputting to both		RGB cable for PC (option)
a PC monitor and the projector.

PC audio cable (option)

Computer

to monitor port

AUDIO OUT

MONITOR OUTPUT

to PC audio output

ENGLISH

For analog connection:

1.Connect one end of the supplied RGB cable to the COMPUTER-IN terminal (1, 2) of the projector.

2.Connect the other end of the RGB cable to the monitor port of the computer.

For monitor connection:

Connect the RGB cable from the monitor to the MONITOR OUT terminal of the projector.

•Images may not be displayed correctly depending on the type of the input signal. See the instruction manual of the monitor.

•Signals are coming from the COMPUTER-IN terminal (1 or 2) of the projector.

•When signals are coming from both COMPUTER-IN terminals (1, 2), images are projected from the terminal (1 or 2) currently or last selected in the projector's menu.

Important:

•When you use a longer RGB cable instead of the provided cable, the image may not be projected correctly.

•Some computers require additional connectors or analog RGB output adapters to be connected with this projector. Contact your dealer for fur- ther information.

•This projector uses stereo pin jack for its audio input. Check the type of the audio output terminal of the connected computer and prepare a proper cable for connection. Some computers don’t have the audio output terminal.

•Speaker output is mono.

•When the audio cable is connected to the AUDIO-OUT terminal, the speaker output is muted.

For Macintosh

•If your Macintosh has no video port, a monitor output adapter is required. Contact your dealer for further information.

•Some Macintoshes require a MAC adapter for the RGB cable for connection with this projector. Contact your dealer for further information.

About DDC

The COMPUTER/COMPONENT VIDEO IN-1 terminal of this projector complies with the DDC 1/2B standard. When a computer supporting this standard is connected to this terminal, the computer will automatically load the information from this projector and prepare for output of appropriate images.

•After connecting a computer supporting this standard to this terminal, plug the power cord of the projector in the wall outlet first, and then boot up the computer.

EN-11