Mitsubishi Electronics ETH-1000 manual Introduction, System Overview, Devices to the, Network

Page 13

ControlLogix PLC Project

c.Click the Open Setting box and enter the first channel as MC Protocol with a proper Host

Station Port number (In this example, the Port Number is set at Hex 5001)

1

3. Download the parameter settings to the PLC.

3-7

	Introduction


	2

	System Overview


	3

Devices to the	Network


	4

ControlLogix PLC Project	Configuration


	5

ETH-1000	Configuration


	6

Using EtherNet/IP	Explicit Messaging


	7

	Terminology

Image 13

Contents Using ICC ETH-1000 EtherNet/IP Interface with Mitsubishi iQ PLC Contents Mitsubishi FURTHER READING REFERENCE LISTThis Page is intentionally left blank Figure 1 EtherNet/IP Connectivity - Rockwell PLC to Mitsubishi iQ PLC Chapter 1 IntroductionFigure 2 Architecture of an Example Verification System Chapter 2 System Overview3.1 Changing the IP Address of the ControlLogix System Chapter 3 Connecting Devices to the Network4. Right-Click on the ENBT Module and select “Module Configuration” from the drop down list 3.2 Changing the IP Address of the ICC ETH-1000 Module Download Configuration to Device pop-up message and the ETH-1000 will go through the reset sequence 3.3 Changing the IP Addresses of the iQ PLC Built-in Ethernet Port ControlLogix PLC Project 3.4 Configuring the External Ethernet Module in the iQ System a. Set the Communication Data Code to Binary 3-10 4.1 Adding the 1756 ENBT Module Chapter 4 ControlLogix PLC Project Configuration4. Then select the proper module 1756 ENBT 3. In the “Select Module” pop-up window, choose the “Communications”revision level of the ENBT module is 4.2 Adding the ICC Module Configuration c. Configure the “Connection Parameters” as follow 5. Configure the RPI to 10.0 ms a. 248 integer tags were created for CSCICCETH1000INTI. These are the tag locations where ICC will transfer the data to the ControlLogix using Implicit Message protocol every RPI 5.1 Configuring the EtherNet/IP Implicit Messaging Communication Chapter 5 ETH-1000 ConfigurationICC ETH-1000 Figure 3 Mapping CLX Data to ICC Database LocationsCSCICCETH100INTI CSCICCETH100INTO 5.2.1. Configuring Connection Objects 5.2 Configuring the MELSEC Protocol5.2.2. Configuring Service Objects 8. Click the “Create” button to create this Service Object b. Define the Service Object to write 10 Words to Internal Relay a. Define the Service Object to read 20 Data Registers to ICCConfiguration 5.2.3. Configuring the Connection Object for QJ71E71 Ethernet Module Mitsubishi iQ Controllers 5.2.4. Calculating the ICC ETH-1000 DB AddressesCLX CSCICCETH100INTI CSCICCETH100INTOChapter 6 Using EtherNet/IP Explicit Messaging Terminology ChapterJuly 2009 - Document created and Released, Version RevisionsRev-1