Mitsubishi Electronics ETH-1000 manual 3-10

Page 16

3-10

3.At the Network Parameter Setting window, click “Open Setting” and open the window below and enter the parameters as shown:

a.Configure the Host Station Port Number to match the Connection Object port number configured in the ICC ETH-1000.

3-10

Image 16

Contents Using ICC ETH-1000 EtherNet/IP Interface with Mitsubishi iQ PLC Contents FURTHER READING REFERENCE LIST MitsubishiThis Page is intentionally left blank Chapter 1 Introduction Figure 1 EtherNet/IP Connectivity - Rockwell PLC to Mitsubishi iQ PLCChapter 2 System Overview Figure 2 Architecture of an Example Verification SystemChapter 3 Connecting Devices to the Network 3.1 Changing the IP Address of the ControlLogix System4. Right-Click on the ENBT Module and select “Module Configuration” from the drop down list 3.2 Changing the IP Address of the ICC ETH-1000 Module Download Configuration to Device pop-up message and the ETH-1000 will go through the reset sequence 3.3 Changing the IP Addresses of the iQ PLC Built-in Ethernet Port ControlLogix PLC Project 3.4 Configuring the External Ethernet Module in the iQ System a. Set the Communication Data Code to Binary 3-10 Chapter 4 ControlLogix PLC Project Configuration 4.1 Adding the 1756 ENBT Module3. In the “Select Module” pop-up window, choose the “Communications” 4. Then select the proper module 1756 ENBTrevision level of the ENBT module is 4.2 Adding the ICC Module Configuration c. Configure the “Connection Parameters” as follow 5. Configure the RPI to 10.0 ms a. 248 integer tags were created for CSCICCETH1000INTI. These are the tag locations where ICC will transfer the data to the ControlLogix using Implicit Message protocol every RPI Chapter 5 ETH-1000 Configuration 5.1 Configuring the EtherNet/IP Implicit Messaging CommunicationICC ETH-1000 Figure 3 Mapping CLX Data to ICC Database LocationsCSCICCETH100INTI CSCICCETH100INTO 5.2 Configuring the MELSEC Protocol 5.2.1. Configuring Connection Objects5.2.2. Configuring Service Objects 8. Click the “Create” button to create this Service Object a. Define the Service Object to read 20 Data Registers to ICC b. Define the Service Object to write 10 Words to Internal RelayConfiguration 5.2.3. Configuring the Connection Object for QJ71E71 Ethernet Module 5.2.4. Calculating the ICC ETH-1000 DB Addresses Mitsubishi iQ ControllersCLX CSCICCETH100INTI CSCICCETH100INTOChapter 6 Using EtherNet/IP Explicit Messaging Chapter TerminologyJuly 2009 - Document created and Released, Version RevisionsRev-1