Various functions common to all the sources
DIMMER
SLEEP
DISPLAY
DIMMER | These buttons | |
may be in a | ||
| ||
| slightly different | |
| position on your | |
| remote controller. |
Changing the display
Press DISPLAY.
Each time you press DISPLAY, the screen changes as follows:
When an input source other than FM or AM is selected
Input source + volume
Program format*
Input source + Listening mode (or Multich)
Press DISPLAY once to initiate the program format display. Pressing the button again switches the display to the other display.
*When the input signal is digital audio
The program format is displayed. For example, the display ÒDolby D: 3/2.1Ó shows that the format is Dolby Digital with 5.1 discrete channels consisting of three front channels (front left, front right, and center), two surround channels (surround left and surround right), and the low frequency effect (LFE) channel.
When the front channel number is 2, they are the front left and front right; when it is 1, it is monaural. When the surround channel number is 1, it is monaural; when it is 0, there is no surround channel. When no LFE number is given there is no LFE channel. Also, if there is no program format for the input signal, nothing will be displayed.
When the input signal is linear PCM
The sampling frequency is displayed. For example, the display ÒPCM fs: 44.1kHzÓ shows that the signal is PCM and that the sampling frequency is 44.1 kHz.
When FM or AM is selected as the input source
FM/AM frequency +
Preset no.
FM/AM +
Listening mode
Controlling the brightness of the display on the AV Receiver
Press DIMMER.
Each press of the button changes the brightness as follows:
→The display becomes less bright.
↓
The display is dimmed.
↓
The display becomes bright.
Using the sleep timer (remote controller only)
Press SLEEP.
ÒSleep 90 minÓ appears in the multipurpose display for about 5 seconds, which means the AV Receiver will turn off and enter standby mode in 90 minutes. Also the SLEEP indicator is lit in the display while the sleep timer is on.
SLEEP indicator
Each press of the button makes the remaining time shorter by 10 minutes.
Checking the remaining time
Press SLEEP while the sleep timer is On.
The remaining time is displayed.
If you press SLEEP while the remaining time is displayed, the remaining time is reduced by 10 minutes.
Canceling the sleep timer
Press SLEEP repeatedly until the SLEEP indicator goes off.
25