Onkyo HT-R420 appendix Connecting antennas, Connecting the supplied FM and AM indoor antennas

Page 14

Connecting antennas

Connecting the supplied FM and AM indoor antennas

ANTENNA

AM	FM	ANTENNA
	75

VIDEO 3 VIDEO 2	VIDEO 1		DVD	MONITOR
IN	OUT	IN	IN	OUT


FRONT			FRONT			CENTER		SURROUND
SPEAKERS B			SPEAKERS A			SPEAKER		SPEAKERS			AC OUTLET
R	L		R	L				R	L

DIGITAL INPUT		S VIDEO
OPTICAL	COAXIAL	REMOTE
		CONTROL

IN

IN

OUT

IN

IN

VIDEO

IN	OUT	IN	IN	IN	OUT	IN	FRONT	SURR
L								L
SUBWOOFER
PRE OUT
R	TAPE							R
CD	TAPE		VIDEO 3 VIDEO 2		VIDEO 1			DVD
								DVD

CENTER

SUB WOOFER

USA, Canada, Mexico

1Strip away the insulation from the end of the cord.

2Fully insert the stripped end of the cord.

				FM	ANTENNA
	AM			FM
	AM		75
			75

Australia

Insert the plug fully into the socket.

Other models

Insert the plug fully into the socket.

Adjusting the position of the FM indoor antenna

The FM indoor antenna is for indoor use only. During use, extend the antenna and move it in various directions until the clearest signal is received. Fix it with push pins or similar implements in the position that will cause the least amount of distortion.

If the reception is not very clear with the attached FM indoor antenna, the use of an outdoor antenna is recommended.

Rotate the outer frame	Insert into the	Extend the
of the antenna.	hole.	antenna cord.

AM indoor antenna

Press and hold up	Insert the end of the	Release the lever to
the lever.	cord.	secure the connection.

AM

FM

75 ANTENNA

Note

Insert one end of the AM antenna cord to either of the AM antenna connectors and the other end to the other connector. There is no difference between one end of the AM antenna cord and the other end, unlike the speaker cables which have positive and negative poles.

Adjusting the position of the AM indoor antenna

The AM loop antenna is for indoor use only. Set it in the direction and position where you receive signals clearly. Put it as far away as possible from the HT-R420, televisions, speaker cables, and power cords.

When reception is not satisfactory with the attached AM loop antenna alone, connection of an outdoor antenna is recommended.

14

Image 14

Contents HT-R420 Important Safety Instructions AvisFor U.S. models PrecautionsPower For Canadian modelsAmplifier Features FeaturesSupplied accessories FM/AM Tuner FeaturesUsing the Remote Controller Before Using the HT-R420Setting the Voltage Selector Worldwide model only Remote control sensor HT-R420 Standby indicator 30˚Index to parts and controls Index to parts and controls Tape IN/OUT Remote ControlRear panel Antenna 14= Mode buttons Remote controllerPreset 2/3 button @ Adjust 2/3 buttonVideo Connection Formats Connecting to audio/video equipmentBefore connecting Satellite tuner, LD Player*5, etc. Video Connecting to audio/video equipmentVideo cassette player Positioning speakers/Connecting speakers Standard speaker placement of the speaker system aConnecting to the speaker system a Positioning speakers/Connecting speakersHow to connect to the speaker terminals Connecting to the speaker system BConnecting antennas Connecting the supplied FM and AM indoor antennasConnecting an Outdoor AM Antenna Connecting antennasConnecting an Outdoor FM Antenna Strip and prepare the 75 ohmPower off function Connections for remote control zPower on/ready function Direct change functionEnjoying music or videos with the HT-R420 Press Speaker Adjust twice Speaker setupSetting the crossover frequency Speaker setup Subwoofer Mode Setting the subwoofer mode Press Subwoofer Mode on the unit→ Subwoofer Mode 1 Default Adjusting each speaker’s relative volume balance Test toneChanging the default settings according to your connections Listening to the radio Tuning into a radio station Press TunerTuning in a weak frequency only for FM stations There are two ways to select radio stationsPress Tuner to switch the input source to the tuner Presetting radio stationsSelecting preset stations Listening to the radioVarious functions common to all the sources Muting the sound remote controller only Press MutingListening through headphones Before operating the SP A/SP BChanging the display Press Display Using the sleep timer remote controller only Press SleepVarious functions common to all the sources May be in a Setting the input signal formatThese buttons Slightly differentBefore operating the Direct or Using analog multi channel inputEnjoying multi channel sources CH SEL Level 5/∞Enjoying the listening modes Press one of the listening mode buttons Selecting the listening modeBefore operating the remote controller Input source and available listening modeUsing the audio adjust functions Audio adjust functionBefore operating the remote control Audio adjust function Video Camera Recording a sourceInput selector buttons Numeric Using the remote controller with your other AV componentsEntering the manufacturer’s code RC-518M only Cable Satellite Using the remote controller with your other AV componentsManufacturer Use the remote controller’s mode buttons i.e Using the RC-518MPoint the remote controller at the HT-R420 Use the input selector buttons to select anVCR mode VCR CD modeTape mode RCVR/TAPE VCRTV mode TV Cable mode CABLE/SAT Satellite mode CABLE/SAT Cable SATTroubleshooting Amplifier Remote controller Symptoms Causes Remedies PagesTuner TroubleshootingSymptoms Causes Remedies OtherVideo Section SpecificationsAmplifier Section Tuner Section

Related manuals

Manual 96 pages 51.33 Kb