Mitsubishi Electronics FC810 manual Mitsubishi Electric Motherboard Division

￿￿￿￿￿￿￿￿￿￿ ￿!￿￿￿ ￿ ￿ ￿ ￿ ￿ ￿ ￿ ￿ ￿ ￿ ￿ ￿ ￿ ￿ ￿ ￿ ￿ ￿ ￿ ￿ ￿ ￿ ￿ ￿ ￿ ￿ ￿ ￿ ￿ ￿ ￿ ￿ ￿ ￿

Do not use excessive force. If the module will not fit easily, remove it and start again.

"￿￿￿￿￿￿￿￿The DIMM!￿￿is inserted vertically and held in place by the clips at each end.

Do not use excessive force. If the module will not come free easily, check that the holding clips are clear of the module ends.

￿￿￿￿￿￿.￿ ￿￿￿￿￿￿￿￿￿￿￿￿0￿￿￿￿￿)￿￿￿￿￿￿￿￿￿

Press￿￿￿￿/￿the tabs on both of the socket’s end clips at the same time. This releases the DIMM and lifts it partly out of the socket.

1.Turn off the computer and unplug all power cords. Take suitable anti-static precautions and remove the system cover.

2.If the system was in use just before starting this procedure, the processor may be hot, wait until it cools

3.Unclip the heatsink/ fan from the processor and lift the clip on the side of the processor socket.

4.The processor can now be removed from the socket.

Caution

Handle the processor with care, by the body only. Avoid touching the connector at the bottom. Store in an antistatic container.

MITSUBISHI ELECTRIC MOTHERBOARD DIVISION PAGE 15 OF 45