Mitsubishi Electronics 1554R user manual Connecting through D-SUB signal connector

Page 12

Connecting through D-SUB signal connector

1. Make sure that the system power is turned off.

2. Connect the computer end of the D-SUB cable to the 15-pin output connector on the video board of your computer.

)To connect the monitor to an older type Apple Macintosh through a D-Sub cable, you need to use an Apple Macintosh signal adaptor to connect the video signal port of your computer to the monitor signal cable. Adaptors are available from Mitsubishi Electric Australia. Please contact your computer dealer for more information.

4

Image 12
Contents 1554R Page Table of Contents Page Copyright Disclaimer Monitor InformationDealer Information Safety Instructions for Display Monitors Maintenance Page Features IntroductionUnpacking the Package Power Management Power Saving FunctionMode Power Consumption Horizontal Green CommitmentInstalling the Monitor Getting StartedConnecting through D-SUB signal connector Adjusting the Monitor Control FunctionsSelect / Adjust Timing SettingFactory Preset Timings Troubleshooting and 4 Useful Hints TroubleshootingNeed More Help? AustraliaNew Zealand Specifications