Preparation/SetUp (continued)
Setting the PJLink™ certification (PJLink certification Mode)
1
Enter “5” and press the Enter key.
•When you don’t use PJLink™ protocol communication, skip this item. (See page 16 for PJLink™.)
2
To enable the PJLink™ certification, enter “1” and press the Enter key. To disable it, enter “0” and press the Enter key. (Default is ON (1).)
Save and exit
1
Enter “9” and press the Enter key.
2
The setting screen is shaded and the setting is updated.
•It takes about 10 seconds for the setting to be updated. Don’t perform communication during this period.
•Because the password, display language, LAN control, and PJLink™ certification are set using the telnet function,
you can also set them on the command prompt window of the personal computer. Enter the following command and press the Enter key.
> telnet [IP address you set] 9999 | [“>” shows a prompt.] |
When setting menu appears, perform the setting procedure as described above.
(Note)
Check that the port number “9999” isn’t blocked by the firewall.