Mitsubishi Electronics FL7000U user manual Setting the password Password Setup, EN-9

Preparation/SetUp (continued)

Setting the password (Password Setup)

1 Enter “0” and press the Enter key.

2	Input the old (current) password and press the Enter
	key. (Default password is admin.)
	• If you input a wrong password, an error message
	appears and the setting menu is displayed again.
	In this case, set the password again.
	• If you forget your password, select “7 factory
	defaults,” input the password “projectorcontroller,”
	and then select “9 save and exit” to perform
	initialization.

3	Input a new password (example: “proj2000”) and
	press the Enter key.
	(Note)
	Use single-byte alphanumeric characters only.

4

Input the new password (example: “proj2000”) again and press the Enter key.

•If you input a wrong password, an error message appears and the setting menu is displayed again. In this case, set the password again.

EN-9