Onkyo SKW-540, SKF-540F, SKB-540, SKM-540S, HT-S790 instruction manual Advanced Setup, Speaker Levels

Advanced Setup—Continued

Speaker Levels

With this function, you can adjust the volume of each speaker so that all speakers can be heard equally at the listening position.

The speaker levels cannot be adjusted while a pair of headphones is connected, speaker set B is on, or the AV receiver is muted.

1		Press the [RECEIVER] button fol-
	RECEIVER	lowed by the [SETUP] button on
		the remote controller.
	SETUP
2		Use the Up and Down [ ]/[ ]

buttons to select “3. Level Cal,” and then press the [ENTER] but- ton.

A pink noise test tone is output by the front left speaker.

3	Turn up the volume so that you
	can hear the test tone suffi-
	ciently.
	While each speaker outputs the test
	tone, its name appears on the display, as
	shown.

4	Use the Left and Right [	]/[ ]
	buttons to adjust the speaker
	level, and use the Down [	] but-
	ton to select the next speaker.

The level can be adjusted from –12 to +12 dB in 1 dB steps (–15 to +12 dB for the subwoofer).

5	Repeat step 4 so that the level of
	the test tone from each speaker
	is the same.
	Speakers that you set to No or None in
	the Speaker Configuration (page 54) do
	not output the test tone.
6	Press the [SETUP] button.
	Setup closes.
	Don’t forget to turn down the volume if
SETUP	you turned it up while setting the levels.

Note:

•A quicker way to adjust the speaker levels is to press the remote controller’s [TEST TONE] button to output the test tone, use the [LEVEL–] and [LEVEL+] but- tons to adjust the levels, and use the [CH SEL] button to select the speakers.

53