Microtek MS4 Starting and Shutting down the Projector, If more than one input device is con

Starting and Shutting down the Projector

1.

2.

3.

4.

5.

Connect the power cord to the projec- tor. Connect the other end to a wall

outlet.

The Power LED and Lamp-ready LED turn on.

Turn on the connected devices.

Ensure the Lamp-ready LED is on a

steady (not flashing) orange and then press the Power button to turn on the

projector.

The projector splash screen displays and connected devices are detected.

If the connected device is an IBM PC,

press [Fn] + [F7] on the computer key- board to switch the display output to

the projector. (Check the user manual of non-IBM PCs to determine the ap- propriate Fn hot keys to change display output.)

If more than one input device is con-

nected, press the Source button repeatedly to switch among devices.

(DVD and HDTV are supported through the DVI-I connector.)

To turn off the projector, press the Power button. The projector prepares for shutdown and a “Wait a moment please…” message appears.

6. When the “Power Off?/Press Power again” message appears, press the Power button. The projector turns off.