Microtek MS4 user manual Regulatory Compliance

Page 43

REGULATORY COMPLIANCE

FCC Warning

This equipment has been tested and found to comply with the limits for a Class B digital device pur- suant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment.

This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communica- tions. Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct the interference at his own expense.

Changes or modifications not expressly approved by the parties responsible for compliance could void the user’s authority to operate the equipment.

Canada

This class B digital apparatus complies with Canadian ICES-003.

Safety Certifications

UL, CUL, CB, TUV-GS, CCC

EN 55022 Warning

This is a Class B product. In a domestic environment, it may cause radio interference, in which case the user may be required to take adequate measures. The typical use is in a conference room, meet- ing room, or auditorium.

Image 43
Contents MS4 DLP Projector Copyright Symbols Used About this manual Table of contents Getting Started Packing ChecklistViews of Projector Parts Front-right viewImage-focus control Top viewTop view -OSD buttons and LEDs DVI-I Connectors viewHoles Bottom viewRemote Control Parts Freeze/unfreezes the on-screen picture Projector and Remote Control Buttons Remote Control Operating RangeInserting the Remote Control Battery Setup and OperationConnect the supplied USB cable from a computer Connecting Input DevicesIf more than one input device is con Starting and Shutting down the ProjectorAdjusting the Projector Level To sharpen the projected image Adjust the Zoom, Focus and KeystoneAdjusting the Volume Navigating the OSD ON-SCREEN Display Menu SettingsOn-Screen Display Menu Controls Setting the OSD Language Input Gamma Brightness Main MenuSetup Menu Config Menu Utility Menu Language Menu Active Source Displays the active source Status MenuReplacing the Projection Lamp Maintenance and SecurityLift the module handle up Resetting the Lamp Cleaning the Projector Cleaning the LensUsing the Kensington Lock Cleaning the CaseCommon problems and solutions TroubleshootingTips for Troubleshooting Image Problems LED Error MessagesHaving the Projector Serviced Lamp ProblemsRemote Control Problems Audio ProblemsPage Specifications SpecificationsInput/output connectors 10m 88m 66m 94m 75m 56m Projection Distance V.S. Projection SizeResolution FH kHz FV Hz Signal mode Timing ChartsDimensions Regulatory Compliance