OTC Wireless 802.11G technical manual WiJET.G System Installation

Chapter 2: WiJET.G SYSTEM INSTALLATION

2.1Safety Statements

Use only the power adapter provided with this product or the manufacturer's authorized replacement power supply.

Connect the power adapter to a properly grounded electrical outlet that is near the product and easily accessible.

Refer service or repairs, other than those described in the user documentation, to a professional service person.

2.2Hardware Installation

2.2.1Power

Power is supplied to the WiJET.G via a 1.7 amps 5 volt DC power adapter.

Warning: use only the power supply adapter provided with this product or the manufacturer’s authorized replacement power supply.

2.2.2 VGA Connection

This is a standard 15 pin female VGA connector where you will connect the WiJET.G to either a monitor or a projector via a straight-thru monitor cable (either purchased separately or with the one that comes with the projector or monitor).

2.2.3 Status LED’s

There are two status LED’s on the WiJET.G. From the front of the unit, the LED on the left is the power indicator while the LED on the right is the link status and video out indicator. During boot-up, the link status LED will initially remain unlit. When the link LED blinks red, it means the WiJET.G is ready for connection to a PC. Upon connection from a computer, the LED will turn solid green. Upon disconnection, the LED will revert to blinking red again.

2.2.4 Hardware Reset Button

The hardware-reset button is located at the back of the WiJET.G. It requires a bent paper clip to access the hardware-reset button. The main function of the hardware- reset button is to reset the WiJET.G unit back to the factory default settings. However, to perform the reset to factory default, the procedure below has to be followed.

1.Turn on or reboot the WiJET.G

2.During the boot-up screen, a message “Reset to factory default” timer starts appears and the user will have approximately 10 seconds to do the following step.

3.Push the hardware reset button on WiJET.G unit before the timer ends. The WiJET.G shall automatically reboot itself.

WiJET.G Technical Manual 3