Nokia M1122, T66280 user manual Local Network Routing

Page 14

Routing page

On the Local Network Routing sub page you can set static routes and enable/disable dynamic routing protocols (Routing Information Protocol version 1 and 2).

To enable dynamic routing to a particular interface select the Routing protocol version from the pull-down list and click the Apply button. RIP versions 1 and 2 are supported. Send v1-compat. v2 option enables the sending of RIPv2 packets using broadcast. Receive v1-compat. v2 option enables the receiving of both RIPv1 and RIPv2 packets.

To add a static route, type in the Destination network IP address, the Subnet mask of the destination network, and the Gateway and the Interface through which the destination network can be reached. Then click the Add new button. There are two static routes in Figure 11.

Figure 11 Local Network Routing page

C33906002SE_00

E Copyright Nokia Networks Oy

13

Page 13 Page 15
Image 14
Page 13 Page 15
Contents Nokia M1122 Introduction to Nokia M1122 Nokia M1122Interfaces Installing M1122Indicator lights M1122 front panel indicators Step-by-step installation procedure Opening a connection Configuring M1122Browser management Main Service Providers pages Service Providers page with PPP configurationService Providers page with Pptp configuration Local Network pages Local ports C33906002SE00 Local Network Dhcp Napt Routing Local Network RoutingStatistics Restart Features Save ConfigData VCC operation LAN interfaceInternal host/gateway interface Network Address Port Translation RoutingBridging Icmp FTP Point-to-Point Tunneling Protocol Pptp Dynamic Host Configuration ProtocolATM and Adsl Choosing the VCC2 for tunneling example Payload encapsulations Weighted Fair Queueing Class of ServicePoint-to-Point Protocol over Ethernet PPPoE Technical specifications AdslBridging Connectors and pin numbering ETH connectorAmbient conditions Ambient conditions, EMC and safetySafety C33906002SE00 C33906002SE00
Top Page Image Contents