INTRODUCTION
This document is intended to resolve common problems that may occur whilst using the Nokia A032 Access Point. It offers useful advice on avoiding general problems and preventing their
1.STARTUP PROBLEMS
This section provides on troubleshooting advice on Access Point initialization (startup) problems.
1.1INITIALIZATION ERROR CODES
If the initialization procedure fails an error code should be displayed on the info LED’s and the alert LED will remain on.
The code should be read from left to right. To identify the code write down each LED as a '1' or '0' depending on its state (on = 1).
For example the pattern:
on on off off on off
would be written:
110010
The table below lists the error codes (a more detailed explanation of each code is given in the section below the table.
Code | Meaning | Log Text |
100001 | Bad code image | <none> |
|
|
|
110000 | Bad PCMCIA hardware | PCMCIA hardware failure |
|
|
|
110001 | No PCMCIA | No PCMCIA card detected |
|
|
|
110010 | Bad PCMCIA card | |
|
|
|
110011 | Bad radio (does not initialize) | Cannot initialize radio |
|
|
|
001000 | Bad DRAM (stuck address) | Memory error type 1 |
|
|
|
001001 | Bad Ethernet RAM (stuck address) | Memory error type 2 |
|
|
|
001010 | Bad CMOS Memory | Configuration error - default loaded |
|
|
|
101000 | LAN controller error | LAN Interface Error |
|
|
|
011000 | Bad configuration | Configuration error |
|
|
|
011001 | Bad Manufacturer's info | Bad unit checksum |
|
|
|
011010 | Bad log sector | Log sector bad — recovered |
|
|
|
011011 | System error | System fault |
|
|
|
© NOKIA INC File: a032trbsv2.doc Date: 15.08.01 | 3/11 |
INTERNET |
|