Bad manufacturers information, Bad log sector

Indicates that the configuration information is corrupted for some unspecified reason. In this case the access point will automatically reset the default values and restart. Put the Access Point into learn mode and reconfigure.

011001: Bad manufacturer's information

Indicates that the internal configuration information has been corrupted. Contact dealer.

011010: Bad log sector

Indicates that the log information in the flash memory has been corrupted. In this case the Nokia A032 will automatically restore an empty log file. The original log and NID name information will be lost but the unit will proceed with initialization. Reenter NID List and WEP information before continuing.

011011: System error

Indicates failure of initialization due to an unknown cause. Power down and then power up Access Point again. If the error re-occurs the unit must be returned to the dealer for repair.

1.2USING THE INITIALIZATION LOG FILE

The Initialization log file keeps a record of each time the Nokia A032 is restarted. You can use it to diagnose start-up problems.

During initialization, as each part of the system is started, entries are made in the log. If the startup is successful the resulting log file changes are written into the flash memory as a record of the event.

The log file can hold data from approximately 30 restarts. After this the oldest entries are overwritten by new entries. To keep a more permanent record, upload the log file periodically using TFTP and save it to disk – see Using the TFTP wireless station program in the Nokia A032 Wireless LAN Access Point User Guide or the A032_User_Guide.pdf file.

1.2.1 An example log file

An example log file is shown below:

Initializing version: 3.00.00 on Tue, 20 Apr 2000 16:19:05

Initialize LAN port...

LAN Port ready: Message. CLM Request

Initializing version: 3.00.00 on Tue, 20 Apr 2000 16:43:28

Initialize LAN port...

LAN Port ready,

The log file shows the following information:

The first line of an entry shows the time at the restart and records the version of Nokia A032 software (in this case 3.00). The next lines show the LAN port is initialized after which the unit is operating normally.

© NOKIA INC File: a032trbsv2.doc Date: 15.08.01	5/11
INTERNET