Pioneer BR-SIT01, BR-SXT01 Ethernet Connection Requirements, Telco Line Connection Requirements

Page 10

10

Supplied with the BR Router

Please check your shipping package for the following items:

•BR Router unit

•Wall-mount power supply

•One DB-25 to DB-25 data and auxiliary interface cable

•Windows RouterView diskette

•Macintosh RouterView diskette

•Windows download software diskette

•Macintosh download software diskette

•RouterView reference guide

•Command line reference guide

•Warranty registration card

Needed For Installation

Before connecting the BR Router to your network, you need to make sure that you have the necessary equipment for connecting to the local Ethernet and the wide area transmission device(s) (modem, 56K CSU/DSU, ISDN terminal adapter, T1 CSU/DSU).

Ethernet Connection Requirements

The BR Router’s Ethernet interface directly supports 10BaseT twisted-pair Ethernet. Other Ethernet cabling types (such as thin Ethernet, thick Ethernet, fiber optic cabling or pre-10BaseT twisted-pair) can be supported using a 10BaseT mini- hub or other conversion device.

10Base-T Twisted-Pair Ethernet

To connect the router’s Ethernet interface to twisted-pair Ethernet cabling you will need an unshielded twisted-pair station cable that is connected to a 10BaseT- compatible twisted-pair hub.

vNote: Ethernet cables and cable connectors are not supplied with the BR Router product. Please contact your reseller or your DCB representative for information on obtaining the correct Ethernet cabling supplies.

Telco Line Connection Requirements

The BR Router is not a line communications device. In order to connect to a wide area transmission line, you must use a modem, 56K CSU/DSU, ISDN Terminal

Page 9 Page 11
Image 10
Page 9 Page 11
Contents BR-SIT01 BR-SXT01 Page Introduction Available on X model router only WAN Interface Frame Relay Configuration Appendix a Shipping Defaults Introduction About the BR RouterGetting Started Getting Started Few NotesEthernet Connection Requirements Telco Line Connection RequirementsInterface Page Ethernet Hardware InstallationConnecting the Router to the Ethernet Mounting the RouterConnecting a Line Device to the BR Router Connecting an Out-of-Band Management Console Powering Up the RouterPage RouterView Software Installation RouterView for WindowsRouterView for Macintosh Page Page Command Line Management Out-of-Band Command Line ManagementTemporarily Reconfiguring a Host for Command Line Management Setting Up Telnet OperationEthernet Interface Configuration Quickstart InstructionsIP Protocol IPX ProtocolAppleTalk Protocol DECnet ProtocolIP Protocol AppleTalk Protocol Link Configuration WAN Interface Frame Relay Configuration Physical Communications SettingsIPX Protocol Frame Relay Dlci Mappings CL Use interfacemisc, wan serialset, and wan connectsetPhysical Communication Settings Ethernet Interface Appendix a Shipping DefaultsWAN Interfaces PPP Appendix B Connector and Cable Pin Outs Pin Outs for V.35 Female Connector DTEAppendix C LED Patterns and Test Switch Settings BR Router LED PatternsBR Router Switch Settings Allow letmein password for 5 minutes after powerup
Top Page Image Contents