Pioneer BR-SIT01, BR-SXT01 manual Ppp

Page 34

34

IPX Defaults

•On

•Unnumbered interface

AppleTalk Defaults

•On

•Unnumbered interface

DECnet Defaults

•Off

V.35 (WAN 0) Link & Physical Defaults

•PPP

•Dedicated

•Sync, external clock

RS-232 (WAN 1) Link & Physical Defaults

•PPP

•Dial-in

•Async @ 115.2Kbps

•Hardware flow control

Image 34

Contents BR-SIT01 BR-SXT01 Page Introduction Available on X model router only WAN Interface Frame Relay Configuration Appendix a Shipping Defaults Introduction About the BR RouterGetting Started Getting Started Few NotesEthernet Connection Requirements Telco Line Connection RequirementsInterface Page Ethernet Hardware InstallationConnecting the Router to the Ethernet Mounting the RouterConnecting a Line Device to the BR Router Connecting an Out-of-Band Management Console Powering Up the RouterPage RouterView Software Installation RouterView for WindowsRouterView for Macintosh Page Page Command Line Management Out-of-Band Command Line ManagementTemporarily Reconfiguring a Host for Command Line Management Setting Up Telnet OperationEthernet Interface Configuration Quickstart InstructionsIP Protocol IPX ProtocolAppleTalk Protocol DECnet ProtocolIP Protocol AppleTalk Protocol Link Configuration WAN Interface Frame Relay Configuration Physical Communications SettingsIPX Protocol Frame Relay Dlci Mappings CL Use interfacemisc, wan serialset, and wan connectsetPhysical Communication Settings Ethernet Interface Appendix a Shipping DefaultsWAN Interfaces PPP Appendix B Connector and Cable Pin Outs Pin Outs for V.35 Female Connector DTEAppendix C LED Patterns and Test Switch Settings BR Router LED PatternsBR Router Switch Settings Allow letmein password for 5 minutes after powerup