Automatically Selecting the Source
Automatically Selecting the Source
1Aim the remote control at the screen and press SOURCE.
a The display looks at each of the connectors and stops on the first one that is receiving a valid picture.
b If this is successful (it may take 10 seconds) stop here.
c If you have several sources connected, press SOURCE again to go to the next one with a picture.
d If you get no picture or have other trouble, see "Manually Selecting the Source" on page 27.
Manually Selecting the Source
1After the display is on, press FREQ/PHASE on the remote. This opens the PICTURE menu.
2Using the up/down arrows, select the SOURCE line and press ENTER.
Picture
| Source |
|
|
| Analog | ||
|
|
|
|
|
|
| |
| Sync Type |
| Separate H&V | ||||
| Vertical Frequency (frame locked) |
| 60Hz | ||||
| Horizontal Frequency |
| 50.00kHz | ||||
| Pixel Frequency |
|
| 80.10MHz | |||
| Mode ID: 31 | HPer: 3178 |
| VLines: 525 | |||
| Horizontal Resolution |
| 1366 |
| |||
|
|
|
|
|
|
|
|
| Vertical Resolution |
| 768 |
| |||
|
|
|
|
|
|
|
|
| Frequency |
|
|
|
| 1602 |
|
| Phase |
|
|
|
| 22.5° |
|
| Sharpness |
|
| 4 |
| ||
|
|
|
|
|
|
| |
| Input Levels |
|
|
|
|
| |
|
|
|
|
|
|
|
|
m70L Installation & Configuration Guide | 27 |