Planar PLL2010MW manual Adjusting the Viewing Angle

Page 10

ADJUSTING THE VIEWING ANGLE

•• For optimal viewing it is recommended to look at the full face of the monitor, then adjust the monitor’s angle to your own preference.

•• Hold the stand so you do not topple the monitor when you change the monitor’s angle.

•• You are able to adjust the monitor’s angle from -4° to 18°.

4

Figure 3

NOTES

•• Do not touch the LCD screen when you change the angle. It may cause damage or break the LCD screen.

•• Careful attention is required not to catch your fingers or hands when you change the angle.

9

Image 10
Contents PLL2010MW Page Table of Contents For Your Safety FCC Class B Radio Frequency Interference StatementPrecautions Before YOU Operate the Monitor FeaturesSpecial Notes on LCD Monitors Package List Product package should include the following itemsInstallation Installation InstructionsStand Base Installation RemoveSignal Cable Controls and Connectors Power CordPower Source Adjusting the Viewing Angle Operating Instructions General InstructionsFront Panel Control Menu / EnterHOW to Adjust a Setting OSD Message1st Sub Description Icon Menu Item Adjusting the PictureMain Menu DCROSD DDC/CIUsing the Right Power Cord Plug & Play DDC2B FeaturePlug and Play Technical Support FAQ Problem & Question Possible SolutionError Message & Possible Solution No Signal Technical Support FAQInput not Support DVI-D SpecificationsAppendix TTLStand Resolution Horizontal Vertical Factory Preset Timing TableFREQUENCYkHZ FREQUENCYHz Connector PIN Assignment PIN no DescriptionWall Mounting Optional Planar Support Cables and Accessories Technical SupportPlanar Support Toll or long distance charges may apply