Planar PLL2010MW manual HOW to Adjust a Setting, OSD Message

Page 13

HOW TO ADJUST A SETTING

1.Press the MENU-button to activate the OSD window.

2.Press + or - to navigate through the functions. Once the desired function is highlighted, press the MENU-button to activate it. If the function selected has a sub-menu, press + or - again to navigate through the sub-menu functions. Once the desired function is highlighted, press MENU-button to activate it.

3.Press + or - to change the settings of the selected function.

4.If you want to adjust any other function, repeat steps 2-3.

Figure 5 The OSD Message

12

Image 13

Contents PLL2010MW Page Table of Contents FCC Class B Radio Frequency Interference Statement For Your SafetyPrecautions Before YOU Operate the Monitor FeaturesSpecial Notes on LCD Monitors Product package should include the following items Package ListStand Base Installation Installation InstructionsInstallation RemoveSignal Cable Controls and Connectors Power CordPower Source Adjusting the Viewing Angle General Instructions Operating InstructionsMenu / Enter Front Panel ControlOSD Message HOW to Adjust a SettingMain Menu Adjusting the Picture1st Sub Description Icon Menu Item DCRDDC/CI OSDUsing the Right Power Cord Plug & Play DDC2B FeaturePlug and Play Problem & Question Possible Solution Technical Support FAQError Message & Possible Solution No Signal Technical Support FAQInput not Support Appendix SpecificationsDVI-D TTLStand Resolution Horizontal Vertical Factory Preset Timing TableFREQUENCYkHZ FREQUENCYHz PIN no Description Connector PIN AssignmentWall Mounting Optional Planar Support Cables and Accessories Technical SupportPlanar Support Toll or long distance charges may apply