Product Use
Operating in 2D mode
Your SD2620W unit can operate
either as a 3D stereoscopic monitor or in the standard 2D mode. Converting to 2D viewing can be accomplished by either turning off the power to one of the monitors or by putting the mirror into the locked upright position. To move the mirror to the raised position, use two hands to slide it up the mirror support arms and then raise it until it drops into the locked position. To lower the mirror, use two hands to lift it out of the locked
slot and then lower it down onto the fine StereoMirror in 2D mode adjustment screws.
The mirror should not be forced down. This can break the glass and damage the mirror frame. The mirror must be pulled forward before lowering.
User controls and OSD menu
The two monitors have a power switch on the right side of the bottom bezel and a power toggle switch on the back. The LED indicator next to the Power button shows the monitor power status. When the LED is green, the power is on. When the LED is amber, the monitor is in
Controls and LED indicator