Connect the cables
The SD2620W unit comes with one 6-foot DVI cable, one 12-foot DVI cable, and one 14-inch DVI cable.
1. | Plug one end of the 6-foot DVI | |
| cable into the primary port of | |
| the dual-channel DVI graphics | |
| card. Plug the other end into | |
| the bottom monitor of the | |
| SD2620W unit. | |
2. | Plug one end of the 14-inch DVI | |
| cable into the secondary output | |
| of the dual-channel graphics | |
| card. Plug the other end into | |
| the input port (labeled “IN”) of | |
| the mirror-flip PCI card. | |
3. | Plug one end of the 12-foot DVI | Short DVI cable installed |
| cable into the output port of the |
| |
mirror-flip PCI card (labeled “OUT”). Plug the other end into the top monitor of the SD2620W unit.
The two monitors must be connected with an off-the-shelf video cable to comply with FCC regulations. Ferrite-core interface cables are provided. This device will not be in compliance with FCC regulations when a non-ferrite-core video cable is used.
User’s Guide 7
