Onkyo TX-SR603X instruction manual Speaker Level Calibration

First Time Setup—Continued

Speaker Level Calibration

This setting is set automatically by the Automatic Speaker Setup function (see page 38).

Here you can adjust the level of each speaker with the built-in test tone so that the volume of each speaker is the same at the listening position.

Note:

The speakers cannot be calibrated while the output of the AV receiver is muted, while a pair of headphones is con- nected, or when using the multichannel input.

	CD	TAPE	TUNER
	7	8	9
				TV VOL
	+10	0	CLEAR
	- - / - - - 10	11	12
	INPUT SELECTOR
		MACRO
	1	2	3	ZONE2
1		REMOTE MODE
	RECEIVER	DVD	CD	HDD
	TAPE/AMP
	TV	VCR	CABLE	SAT
			CDR	MD
	DIMMER			SLEEP
2		NU	ME
		ME
		P	N

2

ENTER

ENTER

Use the Up and Down []/[ ] buttons to select “3. Level Cali- bration,” and then press [ENTER].

The Level Calibration menu appears and the pink noise test tone is output by the front left speaker.

Note:

Speakers that you set to No or None on the Speaker Configuration page (page 44) cannot be selected.

	O		U
	T
+					2, 3
CH		ENTER		VOL
DISC
ALBUM
-					1, 5
PREV	R		P
CH	ET	URN	U
			SET
DISPLAY				MUTING
REC		PLAYLIST		RANDOM

1Press the [RECEIVER] button fol-

RECEIVER lowed by the [SETUP] button.

The main menu appears onscreen.

3	Use the Up and Down [ ]/[	]
	buttons to select each speaker,
	and use the Left and Right [	]/
	ENTER

[ ] buttons to set the volume. The volume can be adjusted from –12 to +12 dB in 1 dB steps (–15 to +12 dB for the subwoofer).

4Repeat step 3 until the volume of the test tone from each speaker is the same.

5Press the [SETUP] button.

The setup menu closes.

Note:

This procedure can also be performed by using the remote controller. First press the [TEST TONE] button to output the test tone. Use the [LEVEL–] and [LEVEL+] buttons to set the volume, and use the [CH SEL] button to select the speakers.

48