Onkyo TX-SR603X instruction manual Recording, Adjusting Individual Speaker Levels

Advanced Operations—Continued

Adjusting Individual Speaker Levels

You can adjust the level of individual speakers while using the DVD analog multichannel input.

Adjusting with onscreen setup menus:

1	RECEIVER	Press the [RECEIVER] button fol-
		lowed by the [SETUP] button.

The main menu appears onscreen.

•While the DVD analog multichannel input is selected, the Automatic Speaker Setup on page 38 and Speaker Configuration settings on page 44 are ignored, and sig- nals from the multichannel input are fed to the front left, front right, center, surround left, and surround right speakers, and subwoofer regardless of those settings.

Recording

This section explains how to record the current input source, how to record one input source while enjoying another, and how to dub audio onto your video record- ings.

Unless you have the full consent of the copyright holder, copyright laws prohibit using your recordings for anything other than personal enjoyment!

2

ENTER

ENTER

Use the Up and Down []/[ ] buttons to select “3. Multich Level Adjust,” and then press [ENTER].

The Multich Level Adjust menu appears.

Notes:

• The surround sound and DSP listening modes cannot

be recorded.

• Copy-protected DVDs cannot be recorded.

• You cannot record from the DVD analog multichannel

input.

• Various restrictions apply to digital recording. Refer

to the manuals supplied with your digital recording

equipment for more details.

• Digital input signals are output by only the digital out-

3		Use the Up and Down [ ]/[	]
		buttons to select each speaker,
	ENTER	and use the Left and Right [	]/

[ ] buttons to set the volume. The volume can be adjusted from –12 to +12 dB in 1 dB steps (–30 to +12 dB for the subwoofer).

Adjusting with the remote controller:

puts, and analog input signals are output by only the

analog outputs. There is no internal conversion from

digital to analog or vice versa.

• DTS signals will be recorded as noise, so don’t

attempt analog recording of DTS CDs or LDs.

1CH SEL

LEVEL- LEVEL+

Use the remote controller’s [CH SEL] button to select each speaker, and then use the [LEVEL–] and [LEVEL+] buttons to adjust the volume.

The level can be adjusted from –12 to +12 dB (–30 to +12 dB for the sub- woofer).

Notes:

•These speaker level settings are completely indepen- dent of those explained on pages 48, 65.

•While the DVD analog multichannel input is selected, you can only select the Direct or Multich listening mode. If you select the DVD analog multichannel input while using another listening mode, that listen- ing mode will be cancelled.

66