Planar CT1905S manual Connecting the Optional Touch Screen, Power Management System

Page 11

Planar User’s Manual

Connecting the Optional Touch Screen

Your LCD Monitor has an optional touch screen feature. If your LCD monitor has this feature, connect the LCD Monitor’s PS/2 connector to your PC’s 9-pin RS232 serial port to enable the touch screen.

1.Install the Touch Screen Drivers to your PC.

2.Following the Touch Screen driver guide to align your touch screen positioning.

Power Management System

The LCD Monitor complies with the VESA DPMS (version 1.0p) power management proposal. The VESA DPMS proposal provides four phases of power saving modes by detecting the horizontal or vertical sync signal. When the LCD Monitor is in power saving mode or detects an incorrect timing, the Monitor screen will go blank, and the power LED indicator will start to blink.

Image 11

Contents Page Page Radio Frequency Interference Statement Planar User’s ManualPREFACE FCC Compliance StatementPreface CHAPTER TABLE OF CONTENTSTABLE OF CONTENTS PREFACEPage Unpacking The LCD MonitorYour new LCD Monitor The LCD Monitor - Rear View Identifying ComponentsChapter The LCD Monitor - Front View2. AC Power Jack Adjusting the Viewing AngleConnecting AC Power 1. Input signal portsConnecting the Stereo Speakers Connecting VideoPower Management System Connecting the Optional Touch ScreenOSD Main Menu Adjusting the DisplayThe Display Controls The LCD Monitor’s Display ControlsSpeaker Volume Use the OSD Adjust OptionThe Display Menu Geometric MenuOSD-V-Position Use the Color Adjust Option1. When there is no input signal OSD-H-Position Use the3. Contrast Adjust Hotkey The hotkey descriptions1. Main Menu pop up /Auto-Adjust Hotkey 2. Audio Volume HotkeyModel TFT LCD Monitor SpecificationsTechnical Information APPENDIX AAPPENDIX B Timing for Model CT1905U UXGA ResolutionSupported Timing Troubleshooting Procedures Troubleshooting