Planar CT1905S manual Planar User’s Manual, Preface, FCC Compliance Statement, Canadian Doc Notice

Page 3
Planar User’s Manual

Planar User’s Manual

PREFACE

FCC Compliance Statement

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:

1.this device may not cause harmful interference, and

2.this device must accept any interference received, including interference that may cause undesired operation.

FCC WARNING

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.

This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.

However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna.

Increase the separation between the equipment and the receiver.

Connect the equipment into an outlet different from that to which the receiver is connected.

Consult the dealer or an experienced radio/TV technician for help.

Caution:

To comply with the limits for an FCC Class B computing device, always use the shielded signal cord supplied with this unit.

The Federal Communications Commission warns that changes or modifications of the unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

CE mark for Class B ITE (Following European standard EN55022/1998; EN61000-3-2/1995; EN61000-3-3/1995, EN55024/1998, EN60950/1992+A1+A2+A3+A4+A11)

Radio Frequency Interference Statement

Warning:

This is a Class B product. In a domestic environment, this product may cause radio interference in which case the user may be required to take adequate measures.

Canadian Doc Notice

For Class B Computing Devices

This digital apparatus does not exceed the Class B limits for radio noise emissions from digital apparatus as set out in the Radio Interference Regulation of the Canadian Department of Communications.

“Le présent appareil numérique n’èmet pas de bruits radioélectriques dépassant les limites applicables aux appareils numériques de la class B prescrites dans le Règlement sur le brouillage radioélectrique édicté par le ministère des Communications du Canada”

i

Image 3
Contents Page Page Radio Frequency Interference Statement Planar User’s ManualPREFACE FCC Compliance StatementPreface CHAPTER TABLE OF CONTENTSTABLE OF CONTENTS PREFACEPage The LCD Monitor Your new LCD MonitorUnpacking The LCD Monitor - Rear View Identifying ComponentsChapter The LCD Monitor - Front View2. AC Power Jack Adjusting the Viewing AngleConnecting AC Power 1. Input signal portsConnecting the Stereo Speakers Connecting VideoPower Management System Connecting the Optional Touch ScreenOSD Main Menu Adjusting the DisplayThe Display Controls The LCD Monitor’s Display ControlsSpeaker Volume Use the OSD Adjust OptionThe Display Menu Geometric MenuOSD-V-Position Use the Color Adjust Option1. When there is no input signal OSD-H-Position Use the3. Contrast Adjust Hotkey The hotkey descriptions1. Main Menu pop up /Auto-Adjust Hotkey 2. Audio Volume HotkeyModel TFT LCD Monitor SpecificationsTechnical Information APPENDIX ATiming for Model CT1905U UXGA Resolution Supported TimingAPPENDIX B Troubleshooting Procedures Troubleshooting