Using the Home Menu |
| Selecting Speakers A and B |
The Home menu provides you quick access to frequently used menus without having to go through the long standard menu. This menu enables you to change settings and view the current information.
The Home menus appear only on a TV that is connected to the HDMI OUT. If your TV is connected to the MONITOR OUT V or the COMPONENT VIDEO OUT, use the AV receiver’s display when changing settings.
1 Press RECEIVER followed by HOME.
The Home menu will be superimposed on the TV screen.
2 Use q/wand ENTER to make the desired selection.
■ Input
`You can select the input source while viewing the information as follows: the name of input selectors, input assignments.
Press ENTER to display the current input source, followed by q/wto select the desired input source. Pressing ENTER again switches to the selected input source.
■ Audio
`You can change the following settings: “Bass”, “Treble”, “Subwoofer Level”, “Center Level”, “Late Night”, “Music Optimizer”, and “Cinema Filter”.
See also:
• “Using the Audio Settings” (➔ page 36)
■Info*1
`You can view the information of the following items: “Input” and “Output”.
■Listening Mode
`You can select the listening modes that are grouped in the following categories: “MOVIE/TV”, “MUSIC” and “GAME”.
Use q/wto select the category and e/rto select the listening mode. Press ENTER to switch to the selected listening mode.
Note
*1 Depending on the input source and listening mode, not all channels shown here output the sound.
You can use two sets of front speakers with the AV receiver: Speakers A for up to
1 Press RECEIVER followed by SP A/B repeatedly to cycle through the selection:
Speakers A → Speakers A&B → Speakers B
→ |
|
| |
|
| ||
|
|
|
|
|
| Off ← | |
Speaker indicators and output channels are shown below.
Speaker | Output channel |
indicators |
|
ASpeakers A: 5.1 channels
A |
| B | Speakers A: 2.1 channels* |
| Speakers B: 2 channels | ||
|
|
|
BSpeakers B: 2 channels No sound
*While Speakers B is on, channels are reduced to 2.1 in the main room.
Tip
•Alternatively, you can use the AV receiver’s SPEAKERS A and B.
Using the Sleep Timer
With the sleep timer, you can set the AV receiver to turn off automatically after a specified period.
1 Press RECEIVER followed by SLEEP repeatedly to select the required sleep time.
The sleep time can be set from 90 to 10 minutes in 10 minute steps.
The SLEEP indicator lights on the display when the sleep timer has been set. The specified sleep time appears on the display for about 5 seconds, then the previous display reappears.
Tip
•If you need to cancel the sleep timer, press SLEEP repeatedly until the SLEEP indicator goes off.
•To check the time remaining until the AV receiver sleeps, press SLEEP. Note that if you press again on SLEEP as the time being displayed is equal or inferior to 10 minutes,
the sleep timer will go off.
En
26