Onkyo TX-SR309 instruction manual Connecting Antenna, Connecting the Power Cord

Page 16

Connecting Antenna

This section explains how to connect the supplied indoor FM antenna and AM loop antenna.

The AV receiver won’t pick up any radio signals without any antenna connected, so you must connect the antenna to use the tuner.

Caution

 

North American and

• Be careful that you don’t injure yourself when

Taiwan models

using thumbtacks.

 

European, Australian and Asian models

Insert the plug fully

Push.

Insert wire.

Release.

into the jack.

Insert the plug fully into the jack.

Assembling the AM loop antenna

Thumbtacks, etc.

AM loop antenna (supplied)

Indoor FM antenna (supplied)

Note

Once your AV receiver is ready for use, you’ll need to tune into a radio station and position the antenna to achieve the best possible reception.

Keep the AM loop antenna as far away as possible from your AV receiver, TV, speaker cables, and power cords.

Tip

If you cannot achieve good reception with the supplied indoor FM antenna, try a commercially available outdoor FM antenna instead.

If you cannot achieve good reception with the supplied indoor AM loop antenna, try using it with a commercially available outdoor AM antenna.

Connecting the Power Cord

1 (Taiwan models)

Connect the supplied power cord to the AV receiver’s AC INLET.

To AC wall outlet

2 Plug the power cord into an AC wall outlet.

En

Note

Before connecting the power cord, connect all of your speakers and AV components.

Turning on the AV receiver may cause a momentary power surge that might interfere with other electrical equipment on the same circuit. If this is a problem, plug the AV receiver into a different branch circuit.

Do not use a power cord other than the one supplied with the AV receiver. The supplied power cord is designed exclusively for use with the AV receiver and should not be used with any other equipment.

Never disconnect the power cord from the AV receiver while the other end is still plugged into a wall outlet. Doing so may cause an electric shock. Always disconnect the power cord from the wall outlet first, and then the AV receiver.

16

Image 16
Contents TX-SR309 Local regulations when disposing of batteries Temperature protection operates if the apparatusAttain an abnormal high temperature 10 cm 4 at the rear. The rear edge of the shelf orPrecautions Supplied Accessories Make sure you have the following accessoriesInstalling the batteries Aiming the remote controllerContents Features AmplifierProcessing MiscellaneousListening Mode buttons Memory button Tuning Mode button Display buttonFront & Rear Panels Front PanelDisplay Remote Control jackRear Panel Remote Controller Controlling the AV ReceiverConnecting the AV Receiver Connecting Your SpeakersConnecting the Speaker Cables Push-type speaker terminalsSpeaker Configuration Speaker Connection PrecautionsUsing a Powered Subwoofer Attaching the Speaker Cable LabelsAbout AV Connections Connected image with AV componentsAV Cables and Jacks Hdmi cableAudio return channel ARC function Connecting Components with HdmiJack Components Assignable How to record the video Connecting Your ComponentsSee Recording to make a connection for video recording Connecting Onkyo uComponents Connecting a Recording ComponentSystem On/Auto Power On Remote ControlConnecting Antenna Connecting the Power CordSee Auto Standby about a power management setting Turning On/Off the AV ReceiverTurning On Turning OffPlayback Controlling Contents of USB DevicesPlaying the Connected Component Understanding Icons on the Display Standard Mode controlPlaying iPod/iPhone via USB Extended Mode control Using the TunerTuning into Radio Stations Playing USB DevicePresetting AM/FM Stations Using RDS excluding North American and Taiwan modelsFinding Stations by Type PTY Displaying Radio Text RTListening to Traffic News TP Using Basic Functions Using the Listening ModesSelecting Listening Modes About Listening ModesOnkyo-Original DSP Listening Modes Speaker LayoutListening Modes Listening modes cannot be selected with some source formats Using the Home Menu Selecting Speakers a and B Using the Sleep TimerSetting the Display Brightness Using the Music OptimizerDisplaying Source Information Changing the Input DisplayUsing Headphones Muting the AV ReceiverRecording AV RecordingOn-screen Setup Menus Advanced SetupCommon Procedures in Setup Menu Hdmi Input Component Component Video InputDigital Audio Digital Audio Input Explanatory NotesSp Config Speaker Configuration Sp Distance Speaker DistanceAudio Adjust Multiplex/Mono SettingsDolby Settings DTS SettingSource Setup Theater-Dimensional Setting NameSync Audio SelectorHardware Hdmi Setup Hdmi Ctrl RihdHdmi Through Audio TV OutUsing the Audio Settings Tone Control SettingsSpeaker Levels Late Night FunctionMusic Optimizer CinemaFILTERMusic Optimizer Cinema FilterIPod/iPhone Playback via Onkyo Dock Using the Onkyo DockControlling Your iPod/iPhone Available buttons Preprogrammed Remote Control Codes Entering Remote Control CodesRemote Control Codes for Onkyo Components Connected via u Controlling Other Onkyo ComponentsResetting Remote Mode Buttons Resetting the Remote ControllerControlling Other Components Controlling a Blu-ray Disc/DVD Player, HD DVD PlayerCassettetape deck Components Buttons DVDplayerDisc + Troubleshooting Can’t turn on the AV receiverAV receiver turns off unexpectedly There’s no sound, or it’s very quietThere’s no sound with a certain signal format Speaker volume cannot be set as requiredAbout DTS signals Only the front speakers produce soundRemote controller doesn’t work Can’t access the music files on a USB deviceStandby power consumption Sound changes when I connect my headphonesVideo Attenuation Video Attoff defaultVideo Atton Gain is reduced by 2 dB Video Connection Formats Connection Tips and Video Signal PathAudio Connection Formats USB Device Requirements USB FeaturesSupported Audio File Formats Supported Audio Formats About HdmiAbout Copyright Protection About p-compatible components Using an RIHD-compatible TV, Player, or RecorderOperations that can be performed with Connection How to connect and setup Confirm the connecting and settingConfirm the settings Operate with the remote controllerSpecifications Amplifier SectionVideo Section Tuner SectionMemo Memo Memo Onkyo Europe Electronics GmbH Onkyo Europe Electronics GmbH UK Branch