Oregon Scientific RRM968P HOW to Program a Preset Station, HOW to USE the Sleep AUTO-OFF Function

GB

decreasing until a clear channel is found. Once this function is	3. Wait for about 5 seconds and the sleep function will be activated
activated, you can release and stop pressing the button.	automatically.

HOW TO PROGRAM A PRESET

STATION

This unit allows you to program up to 8 FM and 8 AM radio stations in the memory. To do so:

1.First press [AM/FM] to select the AM or FM frequency.

2.Select a station number by pressing [STATION].

3.Locate the desired radio frequency by using [+TUNING -].

4.Press and hold [STATION] for 2 seconds to confirm and exit the setting mode.

HOW TO USE THE SLEEP (AUTO-OFF)

FUNCTION

Section III — Indoor Thermometer

DISPLAY OF INDOOR TEMPERATURE

Once batteries are installed into the main unit, it will start to detect the indoor temperature and the data will be displayed. The temperature shown is in degree Celsius (°C). The unit is capable of measuring temperature within the -5°C and +50°C range. If the temperature goes above or below that, “HHH” or “LLL” will be displayed correspondingly.

Section IV — Projection

HOW TO USE THE PROJECTION

With this Sleep function, the radio will be automatically switched off after a pre-set period of time.

1.To set the sleep function, press [SLEEP]. “0 min” will be displayed.

2.Press [SLEEP] again to select the period of time (120, 90, 60, 30 or 15 minutes)(when the function is activated the “Sleep” icon will flash).

The projection makes it easier for you to read the current time or alarm time with alarm status and indoor temperature at night. To use the feature,

1.Press [SNOOZE/LIGHT] to turn on the projection for 5 seconds. The current time with alarm status and indoor temperaturewillbe projected onto the surfacethe lens is facing.

9

RRM968PM_EN_R0 9 7/7/04, 11:01 AM