HOW to USE the Radio

using [VOL +] or [VOL -]. Press [ALARM] to confirm the entry and exit the setting mode. Press [RADIO] to turn off the radio.

When the pre-set time arrives, beep sound / radio will be turned on. Press any key to stop the beep sound. The EL backlight and projection will also activate for 5 seconds.

To enable/disable the alarm, press [ALARM ON/OFF ] when the main unit is in Alarm display mode

When [SNOOZE/LIGHT] is pressed to stop the alarm sound (only when Beep Alarm mode is selected), the unit will re-alarm again after 8 minutes. To disable the snooze function, press [ALARM] or [ALARM ON/OFF ] or press and hold [SNOOZE/LIGHT] for 3 seconds when alarm goes off.

Please note that when Radio is on while Beep Alarm goes off at the same time, the Radio will be temporarily stopped until the Beep Alarm has been turned off.

NOTE ON RADIO ALARM

When the Radio Alarm is turned on, the Radio will be turned on for 2 hours. You can intervene by setting the time period for the Sleep function by pressing [SLEEP] or simply turn off the radio at any time.

each hour. You can activate or deactivate this function by setting this in the clock and calendar setting mode (please refer to Section

“SETTING THE CLOCK AND CALENDAR MANUALLY”).

Section II - Digitally-tuned PLL AM/FM

Radio

Before you start - All radio functions can only be operated when Radio is powered on.

To turn on the radio press [RADIO]. The radio will be turned on at the last preset radio station and volume.

To change the radio frequency, press [AM/FM] to select the radio band. Then use [+TUNING -]to locate the desired radio frequency. Press once and the value will advance by 1 step. Press and hold for 2 seconds to enter the Radio Channel auto-search function.

To change the volume, use [VOL +] or [VOL -]to increase or decrease the volume.There are a total of 16 (0-15) - steps.

To toggle among the programmed stations, press [STATION].

To turn off the radio, press [ RADIO ].

HOURLY CHIME FUNCTION

When the hourly chime function is on, the indication “ ” will be displayed and a beep sound will be given out at the beginning of

AUTO-SEARCH FUNCTION

The unit is equipped with an Auto-Search function and can automatically search for the next clear channel. To activate this function, press and hold [+TUNING -]for 2 seconds and automatically the value of the frequency will keep increasing or

RRM968PM_EN_R0

7/7/04, 11:01 AM