Panasonic AWHE60HN, AWHE60SN, AWHE60SE How to turn the power on and off, WwTurning the power off

How to turn the power on and off (continued)

wwTurning the power off

When performing the operations using the wireless remote control

1Press one of the [CAM1] to [CAM4] buttons on the wireless remote control to select the unit.

2Press the [ON/STANDBY] button on the wireless remote control for 2 seconds.

The unit’s power is turned off.

pp The unit’s status display lamp now lights up orange.

3If a multiple number of units are going to be used, repeat steps 1 and 2 as required.

4Set all the power switches of the units and devices connected in the system to OFF.

Notes

ppWhen transferring to the STAND BY mode (Status display lamp: Orange)

The pan/tilt position is stored in the memory, and the pan/tilt unit is moved so that it points backwards.

ppWhen transferring to the POWER ON mode (Status display lamp: Green (after the initial setting operation is completed))

The pan/tilt unit is moved to the position which was stored in the memory when the transition to the STAND BY mode was made.

ppPOWER ON preset

The pan/tilt unit is moved to the setting, which was established immediately prior to the transition to the STAND BY mode, when the power has been turned on.

ppIf the power is turned off without transferring to the STAND BY mode, the pan/tilt unit position will not be stored in the memory or reflected in the POWER ON preset. The zoom position is stored using the setting established immediately before the power is turned off.

When performing the operations using the controller

When the AW‑RP655 or AW‑RP555 is connected:

1Set the [OPERATE] switch on the controller to OFF.

The power of all the cameras (including the unit) connected to the controller is turned off.

pp The unit’s status display lamp now lights up orange.

2Set all the power switches of the units and devices connected in the system to OFF.

Notes

ppWhen transferring to the STAND BY mode (Status display lamp: Orange)

The pan/tilt position is stored in the memory, and the pan/tilt unit is moved so that it points backwards.

ppWhen transferring to the POWER ON mode (Status display lamp: Green (after the initial setting operation is completed))

The pan/tilt unit is moved to the position which was stored in the memory when the transition to the STAND BY mode was made.

ppPOWER ON preset

The pan/tilt unit is moved to the setting, which was established immediately prior to the transition to the STAND BY mode, when the power has been turned on.

ppIf the power is turned off without transferring to the STAND BY mode, the pan/tilt unit position will not be stored in the memory or reflected in the POWER ON preset. The zoom position is stored using the setting established immediately before the power is turned off.

For further details, refer to the Operating Instructions of the controller.

When the AW‑RP50 is connected:

Refer to the Operating Instructions of the controller.

9