Panasonic AWHE60SN, AWHE60HN, AWHE60SE, AWHE60HE manual Preset memories

Preset memories

This unit enables up to 100 settings for the camera direction (panning and tilting), zoom, focus, iris, gain and white balance to be registered in its preset memories, and called. However, the number of settings that can be registered and called depends on the type of wireless remote control or controller that is used for operation.

ppThe focus and iris operating modes (manual and auto settings) are neither registered nor recalled.

The current focus and iris values are registered.

ppThe focus and iris values can be recalled only when the manual settings are applicable.

ppAWB A, AWB B or ATW is registered as the white balance setting. The values selected when AWB was established

are recalled as the adjustment values of AWB A or AWB B.

ppThe AWB Mode (ATW, AWB A or AWB B) stored using the AW‑RP655 are recalled only when the AW‑RP655 is connected.

Notes

ppWhen there is a large difference in the environmental temperature between the time of registration and the

time the setting is called, displacement of the preset position may occur.

ppIf displacement occurs, perform registration again. pp While preset settings are being called, it is not

possible to perform manual operations such as panning, tilting, zooming or iris adjustments.

pp If, when one set of preset settings has been called, another set of preset settings is then called, the first set of preset settings which have been called will take precedence.

When performing the operations using the wireless remote control

Twelve settings (preset No.1 to No.12) can be registered and called using the wireless remote control.

The [1] to [12] buttons correspond to the unit’s preset memories No.1 to No.12.

qqRegistering the settings in the preset memories

1Display the picture to be shot on the monitor.

Operate the pan, tilt or zoom buttons to determine the camera angle.

Adjust the focus, iris, gain and white balance if they need to be adjusted.

2While holding down the [PRESET] button, press the button corresponding to the preset memory number.

ppIf a preset memory number with an already registered setting has been selected, the existing setting will be erased and replaced with the new one.

qqCalling the settings of the preset memories

1Press the button in which the preset memory setting has been registered.

20