How to turn the power on and off
wwTurning the power on
When performing the operations using the wireless remote control
1Set all the power switches of the units and devices connected in the system to ON.
ppThis unit does not have a power switch.
When power is supplied to it, the status display lamp will light up orange.
The initial operation is then performed, and after this the unit is set to the standby mode.
2Press one of the [CAM1] to [CAM4] buttons on the wireless remote control to select the unit.
3Press the [ON/STANDBY] button on the wireless remote control for 2 seconds.
The POWER ON mode is established, images are output, and control can be exercised.
pp The unit’s status display lamp now lights up green.
Notes
ppIt takes about 30 seconds per unit for the initial settings operation to be completed. During this period, the unit cannot be operated.
(Status display lamp: light up orange)
ppWhen transferring to the STAND BY mode (Status display lamp: Orange)
The pan/tilt position is stored in the memory, and the pan/tilt unit is moved so that it points backwards.
ppWhen transferring to the POWER ON mode (Status display lamp: Green (after the initial setting operation is completed))
The pan/tilt unit is moved to the position which was stored in the memory when the transition to the STAND BY mode was made.
ppPOWER ON preset
The pan/tilt unit is moved to the setting, which was established immediately prior to the transition to the STAND BY mode, when the power has been turned on.
ppIf the power is turned off without transferring to the STAND BY mode, the pan/tilt unit position will not be stored in the memory or reflected in the POWER ON preset. The zoom position is stored using the setting established immediately before the power is turned off.
4If a multiple number of units are going to be used, repeat steps 2 and 3 as required.
The unit’s status display lamp blinks green when a signal matched by the remote control ID has been received, and it blinks orange when a signal that is not matched by the remote control ID has been received.
When performing the operations using the controller
When the AW‑RP655 or AW‑RP555 is connected:
1Set all the power switches of the units and devices connected in the system to ON.
ppThis unit does not have a power switch.
When power is supplied to it, the status display lamp will light up orange.
The initial operation is then performed, and after this the unit is set to the standby mode.
2Set the [OPERATE] switch on the controller to ON.
The POWER ON mode is established, images are output, and control can be exercised.
pp The unit’s status display lamp now lights up green.
Notes
ppIt takes about 30 seconds per unit for the initial settings operation to be completed. During this period, the unit cannot be operated.
(Status display lamp: light up orange)
ppWhen transferring to the STAND BY mode (Status display lamp: Orange)
The pan/tilt position is stored in the memory, and the pan/tilt unit is moved so that it points backwards.
ppWhen transferring to the POWER ON mode (Status display lamp: Green (after the initial setting operation is completed))
The pan/tilt unit is moved to the position which was stored in the memory when the transition to the STAND BY mode was made.
ppPOWER ON preset
The pan/tilt unit is moved to the setting, which was established immediately prior to the transition to the STAND BY mode, when the power has been turned on.
ppIf the power is turned off without transferring to the STAND BY mode, the pan/tilt unit position will not be stored in the memory or reflected in the POWER ON preset. The zoom position is stored using the setting established immediately before the power is turned off.
Before setting the [OPERATE] switch on the controller to ON, be absolutely sure to set all the power switches of the units and devices connected in the system to ON.
For further details, refer to the Operating Instructions of the controller.
When the AW‑RP50 is connected:
Refer to the Operating Instructions of the controller.
8
