20 (GB)
Using On-screen Menus
Auto Shut Off
When you set this item to “On,” the display unit
automatically enters the standby mode when a signal
is not input to the COMPONENT or DVI input
connectors for more than about five minutes. The
display unit automatically enters the power saving
mode when a signal is not input to the DVI or RGB
input connectors for more than about thirty seconds.
While in the standby mode, press the 1POWER
switch on the display unit or the POWER ON button
on the Remote Commander to switch the display unit
on. While in the power saving mode, the display unit
is automatically turned on when a signal is input.
Auto Screen Adjust
When “Auto Screen Adjust” is set to On, it saves the
screen-settings for size and positioning for each input
signal on the unit and automatically detects the last
setting in memory each time input signals are
switched.
When “Auto Screen Adjust” is set to Off, this auto
adjustment is set disabled. Even when input signals
are switched, the original factory settings operate.
Information
This menu is used for displaying various information,
including information on the internal status of the
display unit.
INITIAL SETUP/INFORMATION
Information
Model Name:
Serial Number:
Operation Time:
Software Version:
Set
ENTER
Exit
MENU
Select
Model Name
Indicates the model name.
Serial Number
Indicates the serial number.
Operation Time
Indicates the total number of hours of operation.
Note
Time spent in standby mode is not counted as part of
the Operation Time.
Software Version
Indicates the system software version.
IP Address Setup
Sets an IP address for communication between the
display unit and an optional adaptor with network
management capability (such as BKM-FW32, BKM-
FW50).
DHCP: Automatically obtain an IP address.
Manual: Manually configure an IP address.
For details, see “Setting an IP Address and communication
speed” on page 42 (GB).
Speed Setup
Sets the communication speed between the display
unit and an optional adaptor with network
management capability (such as BKM-FW32, BKM-
FW50).
For details, see “Setting an IP Address and communication
speed” on page 42 (GB).
Note
These setting items appear on the menu only when an
optional adaptor with network management capability
is installed in the OPTION1 slot.
All Reset
This menu is used to reset all adjustment and setting
values to the factory default condition.