Panasonic AWHE60SE, AWHE60SN, AWHE60HN, AWHE60HE manual WwOther 2/2 screen

Camera menu items (continued)

wwOther 2/2 screen

	Other	2/2
Tally Enable			Enable
OSD	Mix
SDI	/COMP	Off ByBrowser
Browser/Video			On
OSD Off With Tally			Off
OSD	Status		Off
Wireless Control			Enable

Return

Tally Enable [Disable, Enable]

“Enable” or “Disable” is set here for the function which turns on or turns off the tally lamp using the tally control signal.

OSD Mix

Whether the camera menus, statuses and other displays are to be turned Off or On can be selected here for each output picture.

SDI(HDMI)/COMP [Off, On, Off ByBrowser] Browser/Video [Off, On]

Off: The camera menus and statuses are not displayed on the output pictures targeted by the setting items listed above.

On: The camera menus and statuses are displayed for the output pictures covered by the setting items listed above.

Off ByBrowser:

If a menu has been opened from the browser screen, the camera menus and statuses are not displayed on the output images for which this setting is established.

Note

ppEven if the display has been set to the off position the camera menus will still be displayed for one minute whenever the power of the unit is turned on.

OSD Off With Tally [Off, On]

This is used to enable or disable the function for clearing the OSD menu displays when the tally signal is received by a command or contact.

When the tally signal is released, the original OSD menu displays are restored.

OSD Status [Off, On]

“Off” or “On” is set here for the status display which appears during AWB operations.

Wireless Control [Disable, Enable]

“Enable” or “Disable” is set here for operations conducted from the wireless remote control.

The operations are enabled when the unit’s power is turned on from an external device other than a wireless remote control, and they are disabled when the power is turned on from a wireless remote control.

Notes

ppAt the point when this item’s setting is changed, the new setting is not reflected in operation.

It is reflected when the unit is set to the standby mode and its power is turned on.

ppFollow one of the procedures below if the item’s setting is changed by mistake and the unit can no longer be operated from a wireless remote control.

When menu operations can be performed using another control device:

First change the item using a control device capable of performing menu operations, and then turn off the unit’s power and turn it back on.

When menu operations cannot be performed using other control devices:

1.Turn off the power of the units and devices that are connected.

2.Disconnect the unit’s power cable, and plug it back in.

3.Perform the operation for turning on the unit’s power from the wireless remote control.

4.After changing this item, turn off the unit’s power and turn it back on.

Return

Use this to return to the previous menu.

50