Oregon Scientific BAR888RA Getting Started, Batteries, Table Stand or Wall Mount, Unit Location

GETTING STARTED

BATTERIES

Batteries are not supplied with this product. You will need to purchase 4 X UM-3 (AA) 1.5V alkaline batteries for the main unit, and 2 X UM-4 (AAA) 1.5V alkaline batteries for the remote sensor.

Insert batteries before first use, matching the polarity as shown in the battery compartment. For best results, install batteries in the remote sensor before the main unit. Press RESET after each battery change.

NOTE It is recommended that you use alkaline batteries with this product for longer performance.

NOTE Do not use rechargeable batteries.

shows when batteries are low.

	EN
TABLE STAND OR WALL MOUNT
The table stand is in the back of the product. See below
for how to assemble the table stand.

2 1

4

3

To mount the product on a wall, put the stand inside the back of the unit and then place it on a wall, as shown below.

UNIT	LOCATION
Main	Indoor Temperature Area
Remote	Outdoor Temperature Area

CHANGE SETTINGS

1.Press and hold MODE for 2 seconds to enter setting mode.

2.Press or to change settings.

3.Press MODE to confirm.

5

2

1

4

3

BAR888RA_EN_R15 5 4/12/05, 9:43 AM